TS-S129

SERVICE BULLETIN
Bulletin Type............: Safety Recall
Subject:Firetrace fire suppression system nozzle
replacement
Bulletin No...............: TS-S129
Bulletin Name..........: Nozzle Replacement
Bulletin Ref No.........: 700003548
Summary:This technical service bulletin gives
instructions about how to replace the nozzles of
Firetrace fire suppression system
Revision No…………...:
NHTSA……………........: 17V777
Bulletin Responsible:Hande YILDIRIM
Release Date..........: 25.07.2018
Published by&Approved by: Mert SALMAN
Vehicle Model..........: TS30
Fiat Rate Code..........: TSS129
Flat Rate Time..........: 45 min
Welding on the Chassis
• Always disconnect the batteries (starting with the negative lead).
• Disconnect the connectors of electrical and electronic equipment (electronic control units, sensors and
actuators) if they are less than 2 meters away from the chassis part to be welded or the earth terminal of the
welding equipment.
• The earth terminal should never be attached to vehicle components such as engine, axles and springs. Arcing on
these parts is not permitted, because of the risk of damage to bearings, springs, etc.
• The earth terminal must make good contact and be placed as close as possible to the part to be welded.
• Plastic pipes, rubber parts and parabolic springs should be well protected against welding spatter and
temperatures higher than 70°.
• The contact switch must not be in the accessory or contact position. The contact key should be removed.
TS-S129 1 / 6
SERVICE BULLETIN
GENERAL PRECAUTIONS
1. Suggested Dress Code:
2. Before Starting the Work:
Always wear protective clothing. Do not wear any damaged or loose-fitting clothing
and remove jewelry before starting the work. In case of long hair use hairnet.
The illustration above shows some of the correct and incorrect clothing that should
be worn during work. Sharp edges should be avoided e.g belts, watches, necklaces etc.
3. Interior materials protection:
Seats, trimming, upholstery stuff and carpeting should be protected with appropriate
coverings.
TS-S129 2 / 6
SERVICE BULLETIN
Instructions
Below instruction needs to be reviewed before the application is done;
TS-S129 3 / 6
SERVICE BULLETIN
Locations of the 4 nozzles for TS30 vehicle are shown as follow;
*Engine bay area;
TS-S129 4 / 6
SERVICE BULLETIN
*Exhaust bay area;
*Compartment behind the drive tire at driver side where fire extinguisher located;
**Please note that locations of the nozzles may vary according to model year of the coach.
TS-S129 5 / 6
SERVICE BULLETIN
RATE BREAK DOWN
Application
Time
Tool Preparations
5 min
Removal Procedure
20 min
Installation Procedure
20 min
Total
45 min
TS-S129 6 / 6