LTB01191NAS2

8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
LT B 0 1 1 9 1 N A S 2
TECHNICAL BULLETIN
21 AUG 2018
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians
with the knowledge, tools, and equipment required to do the job properly and safely. It informs these
Technicians of conditions that may occur on some vehicles, or provides information that could assist in
proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a
Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land
Rover service facility to determine whether this bulletin applies to a specific vehicle.
I N F O R M AT I O N
This reissue replaces all previous versions. Please destroy all previous versions.
Changes are highlighted in blue
SECTION:
303-14
S U B J E C T/ C O N C E R N :
Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored
AFFECTED VEHICLE RANGE:
MODEL:
MODEL YEAR:
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
VIN:
APPLICABILITY:
1/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
MODEL:
MODEL YEAR:
VIN:
APPLICABILITY:
Discovery (LR)
2017-2018
000004-055735
TDV6 3.0L Diesel
Range Rover Velar (LY)
2018
700004-752401
INGENIUM I4 2.0L Diesel
Range Rover Sport (LW)
2016-2018
100003-699492
TDV6 3.0L Diesel
Range Rover (LG)
2016-2018
243372-388449
TDV6 3.0L Diesel
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
SITUATION:
The engine MIL (Malfunction Indicator Lamp) may be illuminated with DTC (Diagnostic Trouble Code)
P0030-29 and/or P2251-13 stored in the Powertrain Control Module (PCM).
CAUSE:
This may be caused by a component fault.
ACTION:
Should a customer express this concern, follow the Workshop and appropriate Diagnostic Procedure
below.
PA RTS :
PART NUMBER
DESCRIPTION
QUANTITY
LR110458
Heated Oxygen Sensor (HO2S)
1
LR016619
Gasket - TDV6
1
LR078958
Gasket - TDV6
1
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
2/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
TOOLS:


Jaguar Land
Rover-approved
Midtronics battery
power supply
Jaguar Land
Rover-approved
diagnostic tool
with latest SDD
Software
Management Pack
Jaguar Land
Rover-approved
diagnostic tool
with latest
PATHFINDER
software
Refer to the
Workshop
Procedure/Worksh
op Manual for any
additional
required special
tools.

WARRANT Y:
NOTES:
Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to JLR claims submission
system to obtain the latest repair time.
The JLR Claims Submission System requires the use of causal part numbers. Labor only claims
must show the causal part number with a quantity of zero.
DESCRIPTION
Heated Oxygen Sensor (HO2S) - Renew - Discovery (L462; TDV6
3.0L Diesel)
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
SRO
19.22.16
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
0.3
01
LR062045
3/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
DESCRIPTION
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
Heated Oxygen Sensor (HO2S) - Renew - Range Rover Velar
(L560; Ingenium I4 2.0L Diesel)
19.22.16
0.1
01
LR062045
Heated Oxygen Sensor (HO2S) - Renew - Range Rover Sport
(L494; TDV6 3.0L Diesel)
19.22.16
0.5
01
LR062045
Heated Oxygen Sensor (HO2S) - Renew - Range Rover (L405;
TDV6 3.0L Diesel)
19.22.16
0.3
01
LR062045
Read and clear Diagnostic Trouble Codes (DTC)
12.90.16
0.2
01
LR062045
NOTE:
Normal Warranty procedures apply.
WORKSHOP PROCEDURE:
1
Inspect the Heated Oxygen Sensor (HO2S) wiring for a short/open circuit condition (see TOPIx
Electrical Information section Electrical Wiring Diagrams 303-14: Electronic Engine Controls).
If a short/open circuit condition is found, repair (see TOPIx Workshop Manual
section 418-02: Electrical Distribution - Wiring Harness - General Procedures Wiring Harness Repair) before continuing with this Technical Bulletin.
When the repair is finished, go to the appropriate Diagnostic Procedure
below.
If a short/open circuit condition is not found, go to Step 2.
2
Replace the Heated Oxygen Sensor (see TOPIx Workshop Manual section 303-14: Electronic
Engine Controls).
DIAGNOSTIC PROCEDURE: SDD
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
4/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
This Diagnostic Procedure is for 2016MY vehicles ONLY.
CAUTIONS:
A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the
vehicle startup battery during diagnosis / module programming.
All ignition ON/OFF requests must be performed. Failure to do these steps may cause
damage to control modules in the vehicle.
1
Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle
startup battery.
2
NOTE:
The Jaguar Land Rover-approved diagnostic tool must be loaded with SDD154.01
Software Management Pack v299 (or later).
Connect the Jaguar Land Rover-approved diagnostic tool to the vehicle and begin a new
session.
3
Follow all on-screen instructions, allowing the diagnostic tool to read the VIN, identify the
vehicle, and initiating the data collect sequence.
4
Read and clear all DTC.
1 Follow all on-screen instructions until the application completes successfully.
2 When all tasks are finished, go to the next Step.
5
Switch the ignition 'ON' and then 'OFF' 3 times.
6
Read all DTCs.
If DTC P0030-29 and/or P2251-13 is not stored, go to Step 7.
If DTC P0030-29 and/or P2251-13 is stored after performing a wiring repair, go to
Step 2 of the Workshop Procedure above.
7
Exit the current session.
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
5/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
1 Select the Session tab.
2 Select the Close Session option.
8
Disconnect the diagnostic tool and battery power supply from the vehicle.
1 When all tasks are complete, release the vehicle. No further action required.
D I A G N O S T I C P R O C E D U R E : P AT H F I N D E R
This Diagnostic Procedure is for the 2017-18MY vehicles ONLY.
CAUTIONS:
A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the
vehicle startup battery during diagnosis / module programming.
All ignition ON/OFF requests must be performed. Failure to do these steps may cause
damage to control modules in the vehicle.
1
Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle
startup battery.
2
NOTE:
The Jaguar Land Rover-approved diagnostic tool must be loaded with PATHFINDER
version 181 (or later).
Connect the Jaguar Land Rover-approved diagnostic tool to the vehicle and begin a new
session.
3
NOTE:
The Jaguar Land Rover-approved diagnostic tool will read the correct Vehicle
Identification Number (VIN) for the current vehicle and automatically take the vehicle
out of Transit mode if required.
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
6/7
8/21/2018
LTB01191NAS2 - Engine MIL Illuminated With DTC P0030-29 and/or P2251-13 Stored | TOPIx
Follow all on-screen instructions.
4
Select ECU Diagnostics.
5
Select All DTCs.
6
Select Clear all DTCs.
1 Follow all on-screen instructions until the application completes successfully.
2 When all tasks are finished, go to the next Step.
7
Switch the ignition 'ON' and then 'OFF' 3 times.
8
Read all DTC.
If DTC P0030-29 and/or P2251-13 is not stored, go to Step 9.
If DTC P0030-29 and/or P2251-13 is stored after performing a wiring repair, go to
Step 2 of the Workshop Procedure above.
9
Exit the current session.
1 If required, reset the vehicle to Transit mode.
2 Select the Exit icon.
10
Disconnect the diagnostic tool and battery power supply from the vehicle.
https://topix.jaguar.jlrext.com/topix/content/document/view?id=922289
7/7