PIT3528D

Service Bulletin Details

Public Details for: PIT3528D

This preliminary information communication provides information to the technician that when the radio is replaced the manufactures "enable counter" will need to be cleared for the led lamp to come on.


- 2009 - 2008 - 2007 - 2006 - 2005 - 2004 - 2003 - 2002 -

Bulletin No.: PIT3528D
Published date: 10/29/2018
Preliminary Information
PIT3528D Radio Theft Light Inoperative after Radio Replacement
and Programming
Models
Brand:
Model:
Model Years:
VIN:
from
to
Engine:
Transmissions:
Buick
Rainier
2004 - 2007
All
All
All
All
Chevrolet
Colorado
2004 - 2009
All
All
All
All
Chevrolet
Trailblazer
2002 - 2009
All
All
All
All
GMC
Canyon
2004 - 2009
All
All
All
All
GMC
Envoy
2002 - 2009
All
All
All
All
Hummer
H3
2006 - 2009
All
All
All
All
Oldsmobile
Bravada
2002 - 2004
All
All
All
All
Saab
97x
2005 - 2008
All
All
All
All
Supersession Statement
This PI was superseded to update model years. Please discard PIT3528C.
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition / Concern
Some owners may comment that the red radio theft LED does not flash after replacing and
programming the radio. This may be due to the "enable counter" internal to the radio not
being reset to 0 counts from the exchange center.
Recommendations / Instructions
During normal driving, the counter will count down to 0 after enough ignition cycles. If an
owner is requesting the LED to operate immediately, the ignition key will need to by cycled
up to 255 times on/off to clear the manufactures "enable counter". To count as a key cycle,
the ignition must be left in the run and off positions for least 3 second each time. On then
Off is considered to be 1 count.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is
resolved without completing every step, the remaining steps do not need to be performed.
© 2018 General Motors. All Rights Reserved.


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.