T-SB-0161-18

Service Bulletin Details

Public Details for: T-SB-0161-18

Tsb: some 2020 model year corolla, corolla hybrid, and corolla hatchback vehicles shipped from japan may have front emergency towing eyelets installed to aid in transportation. Remove the emergency towing eyelets during pre-delivery service


- 2020 -

T-SB-0161-18
December 19, 2018
Emergency Towing Eyelet Removal During PDS
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2020
Corolla, Corolla Hatchback,
Corolla HV
ADDITIONAL INFORMATION
Introduction
Some 2020 model year Corolla, Corolla Hybrid, and Corolla Hatchback vehicles shipped from
Japan may have front emergency towing eyelets installed to aid in transportation.
Remove the emergency towing eyelets during Pre-Delivery Service (PDS) using the procedure in
this bulletin.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
© 2018 Toyota Motor Sales, USA
Page 1 of 4
T-SB-0161-18
December 19, 2018
Page 2 of 4
Emergency Towing Eyelet Removal During PDS
Removal and Installation Procedure
1. Remove the front and rear emergency
towing eyelets from the front and rear
bumpers by turning them counterclockwise.
Figure 1.
NOTE
If it is difficult to loosen the front emergency
towing eyelet, use a steel bar.
1
c
2
1
Front Em ergency Towing Eyelet
2
Rear Em ergency Towing Eyelet
© 2018 Toyota Motor Sales, USA
T-SB-0161-18
December 19, 2018
Page 3 of 4
Emergency Towing Eyelet Removal During PDS
Removal and Installation Procedure (continued)
2. Place one of the removed emergency
towing eyelets into the luggage tray in
the luggage compartment.
Figure 2.
1
NOTE
Dispose of the other removed emergency
towing eyelet.
3
2
3
1
Type A
2
Type B
3
Em ergency Towing Eyelet
© 2018 Toyota Motor Sales, USA
T-SB-0161-18
December 19, 2018
Page 4 of 4
Emergency Towing Eyelet Removal During PDS
Removal and Installation Procedure (continued)
3. Install the front and rear emergency towing
eyelet hole covers, which are stored in the
glove box, on the front and rear bumpers.
Figure 3.
1
c
B
A. Insert the arrow-shaped part of the
emergency towing eyelet hole cover “A”
into the eyelet hole “B” as shown.
A
B. Install the emergency towing eyelet hole
cover to the hole of the bumper.
3
NOTE
Make sure the front emergency towing eyelet
cover is installed in the front, and the rear
emergency towing eyelet cover is installed
in the rear.
2
B
A
4
1
Front
2
Rear
3
Front Em ergency Towing Eyelet Hole Cover
4
Rear Em ergency Towing Eyelet Hole Cover
A
Arrow-shaped Part
B
Eyelet Hole
© 2018 Toyota Motor Sales, USA


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.