XLF-SFT02-12

TECHNICAL SERVICE BULLETIN
Date Of
Issue
YEAR/MODEL
11/2/18
2013-2017
Isuzu Reach
Bulletin
Number
Service Campaign
1002
NO
YES
Title: Hybrid Transit front drive shaft lubrication
Issue: The XL hybrid 130” wheel base Transit front drive shaft
contains two double Carden universal joints. These joints contain a
discreet flush mounted grease fitting that was not referenced in the
XL owner’s manual. Greasing this fitting immediately, and then
every 6000 miles (or regular service interval) is imperative for the
longevity of the ball and socket joint. Typically a failure of this joint
would be preceded by substantial noise or vibration. Driver
feedback will be critical in early detection of a joint that is not
properly lubricated.
Applies To:
All XL Hybrid 130” wheel base Transits.
Safety: Normal safety precautions and PPE should be used.
Special Tools Required: Needle grease fitting
Parts Required: lithium complex soap type extreme pressure grease
with an NLG1 grade2
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment
to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist
in proper vehicle service. Warranty Policy documentation determines Warranty coverage unless stated otherwise in the TSB article. The information in
this Technical Service Bulletin (TSB) was current at the time of printing.
Page |1
TECHNICAL SERVICE BULLETIN
Service Procedure:
1. Raise vehicle on suitable hoist, or jack vehicle and place on
stands. Place vehicle in neutral.
2. Rotate drive shaft to locate and gain access to flush mount
grease fittings. Using needle style grease tip, lubricate ball and
socket joint. (See figure 1)
Figure 1
3. Repeat for rear joint.
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment
to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist
in proper vehicle service. Warranty Policy documentation determines Warranty coverage unless stated otherwise in the TSB article. The information in
this Technical Service Bulletin (TSB) was current at the time of printing.
Page |2
TECHNICAL SERVICE BULLETIN
Warranty Information:
Code
Description
Labor Time
Maintenance
Lubricate drive shaft
.3
Revision History
Revision
Date
Description
1.0
11/02/2018
Initial release
Please contact [email protected] or call 866 414-3212 if you have any
questions.
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment
to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist
in proper vehicle service. Warranty Policy documentation determines Warranty coverage unless stated otherwise in the TSB article. The information in
this Technical Service Bulletin (TSB) was current at the time of printing.
Page |3