A9019162055028_1

90 DTC B200041 stored in the instrument cluster control module
90 19 16 2055028/1 May 15, 2019.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
A3
2017
All
Instrument cluster with color display
A3
2018
1000001 – 1034958
Or
Instrument cluster with color display
A000001 - A064557
Condition
Customer states:
 No customer concerns, it is found during PDI or any other diagnostic work.
Workshop findings:
The following DTC may be stored instrument cluster control module, J285 (address word 0017):
 DTC B200041 (control unit faulty, static).
Technical Background
Diagnostics are too sensitive.
Production Solution
New software in the instrument cluster control module, J285 (address word 0017) addressed the condition.
Service
1. Follow all instructions in TSB 2011732: 00 Software Version Management (SVM), operating instructions.
1. Update the instrument cluster control module, J285 (address word 0017) using the SVM action code as listed
in the table below, if necessary, following the additional instructions stated below:
A vehicle without Audi advanced key (PR Code 4I2):
1. No special procedure required.
Page 1 of 3
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
A vehicle with Audi advanced key (PR Code 4I3):
1. Before starting the update the steering column should be fully extended. This allows full access to the key
reader coil on the right side of the steering column. The ignition key must be held or temporarily taped to the
key reader coil during the update.
2. Start the update on the workshop tester by selecting update and entering the specified SVM code.
3. If the message "…hold the
vehicle key on the
transponder…" appears, hold
the vehicle key as shown in
Figure 1 on the provided
recess of the steering
column. Once the update
starts in the Audi virtual
cockpit keep the holding key
in this position until the
update is completed.
Figure 1. Center console with a mark for the vehicle key.
Model
A3 (2017)
Old Software
Part Number
New Software
Part Number
8V0920872*
8V0920972*
8V0920972*
8V0920873*
8V0920873*
8V0920874*
*
New Software
Version
SVM Code
Input
(or higher)
8V0920872*
8V0920973*
A3 (2018)
Old
Software
Version
8319
8V0920973*
8V0920874*
8V0920974*
8V0920974*
8V0920961*
8V0920961*
8V0920861*
8V0920861*
17A027
0313
Page 2 of 3
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Warranty
Claim Type:
 110 up to 48 Months/50,000 Miles.
 G10 for CPO Covered Vehicles – Verify Owner.
 If the vehicle is outside any warranty, this Technical Service Bulletin is
informational only.
Service Number:
9025
Damage Code:
0039
Labor Operations:
Software Update
0151 0000
Time stated
on the
diagnostic
protocol (Max
100 TU)
Diagnostic Time:
GFF
No allowance
0 TU
Road test prior to the service procedure
No allowance
0 TU
Road test after the service procedure
No allowance
0 TU
Claim Comment:
As per TSB #2055028/1
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.
Additional Information
The following Technical Service Bulletin will be necessary to complete this procedure:
 TSB 2011732, 00 Software Version Management (SVM), operating instructions.
All part and service references provided in this TSB (205028) are subject to change and/or removal. Always
check with your Parts Department and/or ETKA for the latest information and parts bulletins. Please check the
Repair Manual for fasteners, bolts, nuts, and screws that require replacement during the repair.
©2019 Audi of America, Inc. All rights reserved. The information contained in this document is based on the
latest information available at the time of printing and is subject to the copyright and other intellectual property
rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes
at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may
these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Page 3 of 3
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.