A9119632055188_2

91 Individual overhead view cameras are inoperative (picture is blurry or fogged up) DTCs stored in the
driver assist
91 19 63 2055188/2 June 6, 2019. Supersedes Technical Service Bulletin Group 91 number 19-61 dated June 5,
2019 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
A6, A7, A8,
and Q8
2019 - 2020
All
With front and rear view camera system and two side
cameras
Condition
REVISION HISTORY
Revision
Date
Purpose
2
-
Revised Warranty (Updated Q8 Labor Operation)
1
06/05/2019
Initial publication
Customer states:
 One of the overhead view cameras is inoperative.
 One of the overhead view cameras is fogged up.
Workshop findings:
One or more of the following DTC(s) may be stored in the control module for driver assist systems, J1121
(address word 00A5):
 DTC B127C04 (front overhead view camera faulty).
 DTC B127D04 (rear overhead view camera faulty).
 DTC B127E04 (left overhead view camera faulty).
 DTC B127F04 (right overhead view camera faulty).
 DTC B200FFA (internal malfunction) with symptom code 282648 or 282649.
Technical Background
Not applicable.
Production Solution
Page 1 of 4
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Not applicable.
Service
When there is one DTC logged for one of the overhead view cameras:
1. Perform a bus sleep cycle on the vehicle.
2. If the DTC remains static, check the wiring harness between the control module for driver assist systems,
J1121 (address word 00A5) and the affected overhead view camera (R243, R244, R245, or R246) for
loose/unplugged connectors, loose/pushed-back pins, corrosion or damage.
3. In the case that no visual cause can be found:
Swap a new camera with the affected camera to rule out a faulty camera.
Plug the video cable of another camera into the port of the affected camera on the control module for driver
assist systems J1121 (address word 00A5) to rule out a faulty video cable. To do this, the connector housing
of the video cable has to be removed.
Note:
Between each step of the checks, a bus sleep cycle is required to reinitialize the control module and
cameras.
When there are several DTCs stored for the overhead view cameras or the picture is blurry:
1. An individual overhead view camera is fogged up or has a blurred picture.
Due to deviations in the diagnostic capability of the control module for driver assist systems J1121 (address
word 00A5) an individual overhead view camera (e.g. faulty overhead view camera, a short circuit in the
video cable, water ingress, and etc.) can lead to a partial or complete failure of the Topview camera system.
All or some of the above DTCs are logged.
2. Complete the steps listed under the previous section to identify the cause.
3. Replace the fogged up overhead view camera including the wiring harness connector housing and take
photos of the concern for documentation purposes.
Warranty
Claim Type:
 110 up to 48 Months/50,000 Miles.
 G10 for CPO Covered Vehicles – Verify Owner.
 If the vehicle is outside any warranty, this Technical Service Bulletin is informational
only.
Page 2 of 4
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Service Number:
9083
Damage Code:
0040
Labor Operations:
Remove and install overhead view camera
9083 19XX
See SRT
Adjust overhead view camera
9083 1550
See SRT
Remove and install front floor covering
7041 1900
See SRT
Or
7041 1901 (Q8
Only)
7041 1902 (Q8
Only)
Diagnostic Time:
Claim Comment:
Remove and install control unit for driver assist 9093 1950
system
See SRT
GFF
0150 0000
Time stated on
the diagnostic
protocol (Max 100
TU)
Road test prior to the service procedure
No allowance
0 TU
Road test after the service procedure
No allowance
0 TU
As per TSB #2055188/2
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.
Required Parts and Tools
Always check with your Parts Department and/or ETKA for the latest information and parts bulletins.
Part Number
Part Description
Quantity
See ETKA
Fasteners, Bolts, Nuts, and Screws as needed per the
Repair Manual
See ETKA/ELSA
4L0035576K
Connector housing for front area camera
01
Page 3 of 4
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Additional Information
All parts and service references provided in this TSB (2055188) are subject to change and/or removal.
©2019 Audi of America, Inc. All rights reserved. The information contained in this document is based on the
latest information available at the time of printing and is subject to the copyright and other intellectual property
rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes
at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may
these materials be modified or reposted to other sites without the prior expressed written permission of the
publisher.
Page 4 of 4
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.