A9419092054161_2

94 Matrix-design high beam calibration procedure
94 19 09 2054161/2 June 14, 2019. Supersedes Technical Service Bulletin Group 94 number 19-04 dated March
1, 2019 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
A6, A7, A8,
Q8, and etron quattro
2019 - 2020
All
With matrix-design high beams
Condition
REVISION HISTORY
Revision
Date
Purpose
2
-
Revised header (Added e-tron)
1
02/27/2019
Initial publication
Customer states:
 Headlights, including matrix-design high beams, need to be adjusted.
Technical Background
The current headlight aimer does not have the capability to adjust matrix high beams.
While the Matrix Beam functionality is turned off pending NHTSA approval, a dummy value can be written as the
angle calibration value.
Prior to activation of the feature, the Matrix Beam system will be recalibrated with the correct adjustment values.
Production Solution
Not applicable.
Page 1 of 2
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Service
If you have a VAS 621001 or VAS 621001US:
 Please follow the “Matrix LED Headlamp, Adjusting/Calibrating” instructions in Elsa.
Otherwise:
 Enter the value “0” for all angle measurements in the MXB Calibration Test Plan.
Warranty
This TSB is informational only and not applicable to any Audi Warranty.
Additional Information
All parts and service references provided in this TSB (2054161) are subject to change and/or removal. Always
check with your Parts Department and/or ETKA for the latest information and parts bulletins. Please check the
Repair Manual for fasteners, bolts, nuts, and screws that require replacement during the repair.
©2019 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest
information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any
time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in
any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these
materials be modified or reposted to other sites without the prior expressed written permission of the publisher.
Page 2 of 2
© 2019 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.