ITB19-014

Classification:
Reference:
Date:
EL19-013
ITB19-014
June 13, 2019
2013 JX35 AND 2014-2020 QX60; REMOVAL OF HEADLIGHT ASSEMBLY
LOCATING BRACKET
APPLIED VEHICLES:
2013 JX35 (L50)
2014-2020 QX60 (L50)
SERVICE INFORMATION
If replacement of a Front Combination Headlamp assembly (headlight assembly) is necessary, for the applied
vehicles, the locating bracket (if present) on the new replacement headlight assembly must first be removed
before installation.
Inspect the new replacement headlight assembly and confirm if a locating bracket is attached, with a Torx
screw, on top in the center (see Figure 1).
Is a locating bracket present?

NO: This bulletin does not apply. Continue
with the installation of the new replacement
headlight assembly.

YES
Headlight
assembly
1. Using a T10 Torx screwdriver, remove
the locating bracket attached to the topcenter of the replacement headlight
assembly (see Figure 1).
2. Discard the locating bracket and Torx
screw.
3. Continue the installation of the
replacement headlight assembly.
NOTE: Refer to the Electronic Service Manual
(ESM) for the procedure to remove or install a
headlight assembly.
T10 Torx screw
Figure 1
Locating bracket
CAUTION: Take care when installing the headlight assembly so that the painted surface of the fender is not
damaged.

Black electrical tape can be used to protect the edge of the fender while installing the headlight
assembly.
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.
1/2
AMENDMENT HISTORY
PUBLISHED DATE
June 13, 2019
REFERENCE
ITB19-014
DESCRIPTION
Original bulletin published
2/2
ITB19-014