19-01-042H

GROUP
CAMPAIGN
DATE
Technical Service Bulletin
SUBJECT:
NUMBER
19-01-042H
MODEL(S)
DECEMBER, 2019
Certain
2019-2020 Models
2019-2020MY CARB IUMPR DATA COLLECTION (DC1 CAMPAIGN)
(CALIFORNIA DEALERS ONLY)
This bulletin revises TSB 18-01-024 to add 2020MY. Also Causal Part Number has changed.
 IMPORTANT
*** Retail Vehicles ***
California Dealers only must perform this data collection on vehicles whenever an affected vehicle is in the
shop for any maintenance or repair if the vehicle meets the below specified criteria.
When a vehicle arrives at the Service Department, access Hyundai Motor America's "Warranty Vehicle
Information" screen via WEBDCS to identify open Campaigns.
Description:
This bulletin provides information and procedures for collecting OBD “In Use Monitor Performance
Ratio” (IUMPR) data on certain 2019-2020MY vehicles at California dealers. This reporting is mandated
by CARB (California Air Resources Board).
Data is no longer submitted to Hyundai by datasheet and dealer email. Data is sent electronically by
GDS when the procedure of this bulletin is followed.
Affected vehicles must meet ALL of the following criteria to be eligible for DC1:
 WebDCS shows this as an open campaign for Data Collection code DC1 for the vehicle.
 Vehicle has over 3000 miles on its odometer.
 Vehicle has not had an ECM Update on this service visit.
 Vehicle has not had its battery replaced/disconnected during this service visit.
 Vehicle does not have a check engine light on.
NOTE: This campaign procedure must be performed prior to completing any other open campaigns.
Applicable Vehicles:
All 2019-2020MY vehicles with an open DC1 data collection Campaign.
Warranty Information:
Model Year
Op Code
Operation
OpTime
Causal Part
Nature
Cause
2019
CCARB019
IUMPR Data Collection
0.4
NTF00 00000
I74
ZZ4
2020
CCARB020
IUMPR Data Collection
0.4
NTF00 00000
I74
ZZ4
NOTE: Submit Claim on Campaign Claim Entry Screen.
Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians
SUBJECT:
2019-2020MY CARB IUMPR DATA COLLECTION (DC1)
Service Procedure:
A. Collection of IUMPR Data:
1.
Connect GDS Mobile to the vehicle with the
ignition ON (engine does not need to be
running).
a. GDS Mobile should have Auto VIN at
initial VCI communication with the
vehicle. Confirm that correct vehicle
appears at top of the screen.
b. Select the IUMPR function from the
More section after pulling it up from the
bottom of the screen.
TSB #: 19-01-042H
Page 2 of 6
2019-2020MY CARB IUMPR DATA COLLECTION (DC1)
SUBJECT:
2.
Select DC1 IUMPR Start.
 NOTE
Make sure GDS is connected to the
internet. It must be able to confirm
the vehicle has an open DC1
campaign.
The following DC1 IUMPR Data Collection
screen should open in the event the vehicle
has an open DC1 campaign.
 NOTE
You may receive an error screen if
internet is not connected, vehicle
doesn’t have an open DC1
campaign, or if any of the other
conditions specified on page-1
does not apply.
3.
a) Enter the applicable information
accurately into each field.
 NOTE
Test Group is found on the engine
underhood emissions label.
b) Then select DC1 IUMPR Data
Collection Start.
TSB #: 19-01-042H
Page 3 of 6
2019-2020MY CARB IUMPR DATA COLLECTION (DC1)
SUBJECT:
4.
The following screen confirms your entered
information and the first page of collected
IUMPR data.
 NOTE
Confirm the correct VIN was
successfully captured by the initial
GDS Auto VIN.
5.
Scroll the screen down to the second page
until the Send button appears.
Select Send to transmit collected data to
Hyundai’s server.
 NOTE
Valid data should not contain “0”
for values at most parameters.
TSB #: 19-01-042H
Page 4 of 6
SUBJECT:
6.
2019-2020MY CARB IUMPR DATA COLLECTION (DC1)
This screen will confirm GDS has
successfully electronically transmitted the
vehicle’s IUMPR data to Hyundai’s server.
This data will be consolidated later to
submitted claims to automatically approve
claims payment.
Select Print to get a record of the IUMPR
data collection to attach to the repair order
as evidence of collection.
 NOTE
Submission of a printout by dealer
email is no longer required for
claim payment. The data should
be transmitted electronically by
GDS. However, your printout will
serve as claim evidence in the
event the GDS fails to send it
electronically.
7.
In the event of an unsuccessful
transmission of data, the following error
screen may occur:
a) Refer to Section-B on page-6 to confirm
if status shows pending meaning that
the data has been captured by GDS and
will automatically send when internet is
later restored.
b) Should Section-B not show a status of
pending or sent out succesfully for the
applicable VIN, then the above collection
procedure steps 1-6 will need to be
repeated.
TSB #: 19-01-042H
Page 5 of 6
SUBJECT:
2019-2020MY CARB IUMPR DATA COLLECTION (DC1)
B.
Checking IUMPR Data Transmission Status:
1.
Select Status Check from the DC1 IUMPR
Data Collection screen.
2
The Data Transmission Status Check
screen will display the following:

SENT indicates IUMPR data has been
sent succesfully to Hyundai’s server.

Pending indicates IUMPR data was
collected and saved in GDS, but
remains to be sent automatically to the
Hyundai server once an internet
connection is later established.
You may try Send All Pending if you
have just connected to the internet,
otherwise it will be sent automatically
once internet is restored. You can
confirm transmission status later.
This list by default will contain the most
recent data collected by the particular GDS
being used.
A particular VIN or Repair Order number
(RO No.) or Date range can be entered at
the top search section to find past collected
data sent from the particular tablet.
3.
To display past collected data, select any
case on the list to view it. The data will look
like that shown on Section-A Steps 4-5.
Scroll the screen down to the 2nd page of
the data to Print.
4.
Procedure Complete.
TSB #: 19-01-042H
Page 6 of 6