PIP5697A
Service Bulletin Details
Public Details for: PIP5697A
This preliminary information communicates a possible bcm concern ifdtc P0747 sets during engine cranking when the transmission is in park.
Models from 2020
Models from 2019
Models from 2018
2018 BUICK ENCLAVE |
2018 BUICK ENVISION |
2018 BUICK LACROSSE |
2018 BUICK REGAL |
2018 CHEVROLET CRUZE |
2018 CHEVROLET EQUINOX |
2018 CHEVROLET MALIBU |
2018 CHEVROLET TRAVERSE |
2018 GMC TERRAIN |
Models from 2017
2017 CHEVROLET CRUZE |
2017 CHEVROLET MALIBU |
Bulletin No.: PIP5697A Published date: N/A Preliminary Information PIP5697A DTC P0747 Setting At Engine Start-Up When The Transmission Is In Park Models Brand: Model: Model Years: VIN: from to Engine: Transmissions: Buick Enclave 2018 - 2020 ALL ALL ALL M3W Buick Encore GX VIN M 2020 ALL ALL ALL M3F Buick Envision 2018 - 2020 ALL ALL ALL M3T Buick LaCrosse 2018 - 2019 ALL ALL ALL M3G Buick Regal 2018 - 2020 ALL ALL ALL M3D M3T Cadillac XT4 2019 - 2020 ALL ALL ALL M3H Cadillac XT5 2020 ALL ALL ALL M3G M3W Cadillac XT6 2020 ALL ALL ALL M3G M3W Chevrolet Blazer 2019 - 2020 ALL ALL ALL Chevrolet Cruze 2017 - 2019 ALL ALL ALL M3D Chevrolet Equinox 2018 - 2020 ALL ALL ALL M3D Chevrolet Malibu 2017 - 2020 ALL ALL ALL M3E Chevrolet Traverse 2018 - 2020 ALL ALL ALL M3V GMC Acadia 2020 ALL ALL ALL M3G M3H M3W GMC Terrain 2018 - 2020 ALL ALL ALL M3H M3U Involved Region or Country North America and NA Exports. Condition DTC P0747 may set during engine start-up when transmission is in park. Cause The concern may be that the BCM is not continuing to supply ignition voltage to the TCM after engine running shut down to allow the modules to perform the powerdown self test. If ignition voltage is not present from the BCM connector X4, terminal 22, for a minimum of 15 seconds after the ignition is cycled o , the modules will not complete the power down self test, and then during engine cranking will see data from wherever the self test stopped, typically will see engine RPMs during cranking, and may set DTC P0747. Correction: If ignition voltage is not present for the minimum 15 seconds from the BCM after ignition is cycled o after the engine has been running, check all BCM powers and grounds and if no concern found, replace and re-program the BCM. * This P/I will be updated or advanced to a TSB, if needed. Version History Version Modi ed 2 01/08/2020 - Created on. 03/27/2020 - Updated to add the 2020 Encore GX. © 2020 General Motors. All Rights Reserved.