JLRTB02043NAS1

Service Bulletin Details

Public Details for: JLRTB02043NAS1

1 or both of the air deflectors installed on the rocker panel moldings may become loose/adrift over time. They may rotate around the retaining scrivet and come in contact with the rear tires, causing a rubbing noise.


- 2021 - 2020 - 2019 -

Models from 2021
2021 JAGUAR I-PACE
Models from 2020
2020 JAGUAR I-PACE
Models from 2019
2019 JAGUAR I-PACE 
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
JLRTB02043NAS1
TECHNICAL BULLETIN
09 JUN 2020
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional
Technicians with the knowledge, tools, and equipment required to do the job properly and
safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not
be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition
described affects your vehicle. Contact an authorized Land Rover service facility to
determine whether this bulletin applies to a specific vehicle.
INFORMATION
SECTION:
501-08
SUBJECT/CONCERN:
Air Deflector Loose/Adri
AFFECTED VEHICLE RANGE:
MODEL:
I-PACE (X590)
MODEL YEAR:
2019 Onwards
VIN:
F60001 Onwards
ASSEMBLY PLANT:
Graz (Austria)
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
1/6
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
SITUATION:
1 or both of the air deflectors installed on the rocker panel moldings may become
loose/adri over time. They may rotate around the retaining scrivet and come in contact
with the rear tires, causing a rubbing noise.
CAUSE:
Retention loads lower than expected.
ACTION:
Follow the instructions below.
PARTS:
NOTE:
Only install a new air deflector if the original air deflector is damaged or missing.
PART NUMBER
DESCRIPTION
QUANTITY
C2S9354020
Retaining scrivets (up to 4 new retaining scrivets
may be required if installing 2 new air deflectors)
2/3/4
T4K9937
Le air deflector (if required)
1
T4K9936
Right air deflector (if required)
1
WARRANTY:
NOTES:
Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Use TOPIx to obtain
the latest repair time.
The JLR claims submission system requires the use of causal part numbers. Labor
only claims must show the causal part number with a quantity of zero.
DESCRIPTION
JLRTB02043 - Air deflector
modification
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL PART
99.01.16
0.2
33
T4K9937/T4K9936
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
2/6
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
NOTE:
Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1.
Raise and support the vehicle (see TOPIx Workshop Manual section 100-02:
Jacking and Li ing - Description and Operation - Jacking and Li ing).
Vehicles that require a new air deflector only
2.

Install the new le air deflector.
Secure the 2 retaining clips.
Install the retaining scrivet.
All vehicles
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
3/6
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
3.

Measure and mark the position on the le air deflector for drilling, as shown in the
illustration.
4.

Using a 6 mm drill, create a hole through the le air deflector and the le rocker
panel molding in the position marked during step 3.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
4/6
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
5.

Remove the le air deflector.
Remove the retaining scrivet.
Release the 2 retaining clips.
6.

Using a 10 mm drill, increase the size of the new hole in the le air deflector from 6
mm to 10 mm.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
5/6
6/9/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
7.

Install the le air deflector.
Secure the 2 retaining clips.
Secure the 2 retaining scrivets.
8.
Repeat steps 2 to 7 for the right air deflector.
9.
Lower the vehicle (see TOPIx Workshop Manual section 100-02: Jacking and
Li ing - Description and Operation - Jacking and Li ing).
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1591713337442
6/6

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.