JTB00632NAS2

12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
JTB00632NAS2
TECHNICAL BULLETIN
16 DEC 2020
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional
Technicians with the knowledge, tools, and equipment required to do the job properly and
safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not
be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition
described affects your vehicle. Contact an authorized Jaguar service facility to determine
whether this bulletin applies to a specific vehicle.
INFORMATION
This reissue replaces all previous versions. Please destroy all previous versions.
This bulletin supersedes TSB JTB00632NAS1/2018 dated 28 MAR 2018, which should either
be destroyed or clearly marked to show it is no longer valid (e.g. with a line across the page).
Only refer to the electronic version of this Technical Bulletin in TOPIx.
Changes are highlighted in blue
SECTION:
413-00
SUBJECT/CONCERN:
Diesel Exhaust Fluid Refill Warning Message Displayed
AFFECTED VEHICLE RANGE:
MODEL:
F-PACE (X761)
MODEL YEAR:
2018
VIN:
099558-099607
ASSEMBLY PLANT:
Solihull
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
APPLICABILITY:
INGENIUM I4 2.0L Diesel
1/5
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
MODEL:
MODEL YEAR:
VIN:
ASSEMBLY PLANT:
APPLICABILITY:
F-PACE (X761)
2018
898829-899997
Solihull
INGENIUM I4 2.0L Diesel
F-PACE (X761)
2018
240000-299999
Solihull
INGENIUM I4 2.0L Diesel
F-PACE (X761)
2018
201651-237479
Solihull
XE (X760)
2018
P16865-P46412
Castle Bromwich
INGENIUM I4 2.0L Diesel
XF (X260)
2018
Y53235-Y73375
Castle Bromwich
INGENIUM I4 2.0L Diesel
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
NOTE:
Pune assembled vehicles are affected by this technical bulletin.
SITUATION:
An inappropriate Diesel Exhaust Fluid (DEF) refill warning message displayed on the
message center.
CAUSE:
Software error.
ACTION:
Follow the instructions below.
TOOLS:
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
2/5
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394

Jaguar Land Rover (JLR)
approved diagnostic equipment

JLR approved battery support
unit
WARRANTY:
NOTES:
Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Use TOPIx to obtain
the latest repair time.
The JLR claims submission system requires the use of causal part numbers. Labor
only claims must show the causal part number with a quantity of zero.
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
XE and XF - Instrument Panel Cluster Control Module
(IPC) Virtual - Update - Replace ECU
86.95.61
1.0
04
T2H15460
F-PACE - IPC Virtual - Update - Replace ECU
86.95.61
0.9
04
T2H15460
DESCRIPTION
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
3/5
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
NOTE:
Normal Warranty procedures apply.
DIAGNOSTIC INSTRUCTION:
1.
CAUTIONS:
This procedure requires a minimum of Pathfinder 310 installed or later.
All ignition ON/OFF instructions must be followed. Failure to complete
these instructions may cause damage to the vehicle control modules.
NOTE:
The JLR approved diagnostic equipment will read the Vehicle Identification
Number (VIN) for the vehicle and automatically take the vehicle out of
‘Transportation Mode’ if required.
Connect the JLR approved battery support unit.
2.
Connect the JLR approved diagnostic equipment to the vehicle and begin a new
session.
3.
Follow the JLR approved diagnostic equipment prompts.
Select 'ECU Diagnostics'.
Select 'Instrument Panel Cluster Control Module [IPC]'.
Select 'ECU Functions'.
Select 'Instrument Pack - partial update ECU without graphics'.
Follow all on-screen instructions to complete the task.
4.
If required, reset the vehicle to ‘Transportation mode’.
5.
When all of the tasks are complete, exit the session.
6.
Disconnect the JLR approved diagnostic equipment and the JLR approved battery
support unit.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
4/5
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124065394
5/5