20-037 TSB

SUPER SLIDE OUT OPERATION
Bulletin
Type:
Publication
Date:
TSB
January 28 , 2021
Bulletin #(s):
20-037
Make(s):
ENTEGRA
Job Code(s):
9803561
Model(s):
REATTA XL (MC)
Flat Rate(s):
Inspection only no repair .25 Hour
Inspect and install .75 Hour
Incident:
Affected Units:
Model Year(s):
2021
POWER SOURCE TO OPERATE THE SLIDE OUT IS NOT SUFFICIENT
M1MC8051 – M1MC8064
Parts Kit #: 20-037EN
Parts Kit Contents:
Parts Kit:
Misc. Tools & Supplies:
RELAY BLOCK
HARNESS
BREAKER
DECAL
(4) FLAT HEAD SCREWS
(2) WASHER HEAD SCREWS
SCREW GUN, # 2 SQUARE BIT, DE-PINNING TOOL(amp 18040301), 3/8” DEEP WELL SOCKET, RATCHET
20-037 Power Gear Slide Power Source
January 2021
Page 1 of 3
INSPECTION
Access electrical compartment in passenger cargo bay #3.
Verify if the relay shown below is present. If not, please
proceed with step 1 of instructions.
INSTRUCTIONS
1. Install breaker in line of breakers. (Note: there is an
empty slot for it) as shown in picture to the right.
2.
Install relay block just
above the breakers.
As shown in the
pictures to the left
20-037 Power Gear Slide Power Source
January 2021
Page 2 of 3
3.
Unplug the 8- pin
connector from G-12. As shown in
the picture to the left
4.
De-pin, wire 1 and 2 (gray
and gray/black wires) as shown in
picture to the right
5. Insert wires into 2 pin connector of harness provided,
matching colors on connector
6. Insert orange and blue wire into 8 Pin connector on G12 in place of the gray wires you just removed
a. Orange in position 1
b. Blue in position 2
7.
Connect red wire(ring terminal) to breaker that you installed
8.
Connect black wire(ring terminal) to ground bar in electrical
compartment
9.
Plug in 8 pin connector to G-12
10.
Plug 6 pin connector to relay that you installed
11.
Apply new label beside breakers
12.
Test operation of slide out.
Jayco’s sole obligation under our limited warranty is to repair or replace defective materials and/or workmanship deemed our responsibility as determined
by Jayco in our sole discretion. Jayco reserves the right to use new and/or remanufactured parts or materials of similar quality to complete any work, and to
make parts and/or design changes as appropriate without notice to anyone. Jayco designs and/or materials changes are done without obligation to
incorporate such changes in previously manufactured product. Jayco makes every reasonable effort to ensure field remedies will not adversely affect
performance and/or safety of the unit. This field remedy is not intended to extend to future performance of this RV, or any of its materials, components or
parts beyond the standard warranty period. The RV owner’s obligation to notify Jayco, or one of its independent, authorized dealers, of a claimed defect
does not modify any obligation placed on the RV owner to contact Jayco directly when attempting to pursue remedies under state or federal law. Jan. 2019.
903 South Main Street • P.O. Box 460 • Middlebury, IN 46540
20-037 Power Gear Slide Power Source
January 2021
Page 3 of 3