NTB13049

Classification:
BT13-011
Reference:
Date:
NTB13-049
May 1, 2013
2013 ALTIMA SEDAN;
DOOR MIRROR CORNER FINISHER REMOVAL PROCEDURE
APPLIED VEHICLE: 2013 Altima Sedan (L33)
SERVICE INFORMATION
If the door mirror corner finisher of either front door has to be removed or replaced for
any reason, make sure to remove it as noted below.
NOTE: The front door finisher must be removed prior to door mirror corner finisher
removal. Refer to the L DRIVER CONTROLS>MIR Mirrors section of the Electronic
Service Manual (ESM).
Upper fastened area
Push
suitable trim tool
underneath
finisher, and
then pry outward
as shown. Move
tool further up
near upper
fastened area,
and then pry
outward again.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/1