NTB13053

Classificatio n:
EL13-014
Reference:
Date:
NTB13-053
May 13, 2013
BEFORE REPLACING A CAN GATEWAY MODULE
APPLIED VEHICLES:
2013 Pathfinder (R52)
IF YOU CONFIRM:
On an applied vehicle with a “CAN Gateway Module” that Multiple CAN system DTCs are
present.
•
If the CAN Gateway Module is not configured properly, multiple CAN system DTCs can
occur, as well as some components on the CAN circuit 2 and ITS-CAN may not
function.
ACTION:
Use CONSULT-III plus (C-III plus) to manually over-write the data in the CAN Gateway
Module.
•
DO NOT perform a “Read Configuration” of the original configuration first.
•
See the Service Procedure on Page 2.
CLAIMS INFORMATION
Submit a Primary Part (PP) type claim using the following claims coding:
OPERATION
PFP
OP CODE
SYS
DIA
FRT
Over-write CAN Gateway Module
(1)
RX3RAA
ZE
32
0.3
(1) Refer to the electronic parts catalog (FAST) and use the CAN Gateway Module
(284D1-XXXXX) assembly part number as the Primary Part (PFP).
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3
SERVICE PROCEDURE:
Before considering replacing a CAN Gateway Module for possibly setting DTCs or causing
other components to not operate properly:
Perform a write configuration with C-III plus
using the Manual Configuration mode and
then the auto function to “over-write” the
vehicle’s configuration to the CAN Gateway
Module.
•
DO NOT perform a “Read
Configuration” of the original
configuration first.
•
C-III plus will write the correct
configuration based on the vehicle’s
type.
Select Manual
Configuration
Figure 1
1. Navigate CIII-plus to the reprogramming
screen in Figure 1.
2. Select Manual Configuration.
•
Select
Next
The screen in Figure 2 will then be
displayed, but will not display a
model or a manually configurable
list.
NOTE: Manual configuration data for
the CAN Gateway Module cannot be
viewed through C-III plus (blank screen)
and an incorrect configuration can be
unintentionally transferred from the
original CAN Gateway Module to the
new module.
No configuration
will be displayed
Figure 2
Select
OK
3. Select Next (Figure 2).
4. Select OK.
¾ Proceed to step 5 on page 3.
No configuration
will be displayed
Figure 3
2/3
NTB13-053
5. After performing an auto over-write:
a. Erase DTCs in all systems.
b. Cycle the ignition.
c. Erase all DTCs a second time and wait for 2 seconds or more, and then confirm that
any components that did not respond now function correctly.
6. If no other DTCs are present and all components now function correctly, do not replace
the CAN Gateway Module.
If the CAN Gateway Module must be replaced, DO NOT read the original vehicle
configuration of the original CAN Gateway Module to C-III plus before replacement.
•
After replacing a CAN Gateway Module with a new or used unit, use steps 1 and 2
to over-write the CAN Gateway Module’s configuration.
IMPORTANT:
¾ If you set the incorrect “Read / Write Configuration”, DTCs may occur and some
systems might not respond or operate.
3/3
NTB13-053