ITB14057

Classification:
Reference:
Date:
EL14-052
ITB14-057
December 1, 2014
2014-2015 Q50; CONFIGURING CAN GATEWAY
APPLIED VEHICLE: 2014 – 2015 Q50 (V37)
2014 – 2015 Q50 Hybrid (V37)
SERVICE INFORMATION
After replacement of a CAN Gateway Module, the new module must be configured with the correct part number
to complete the repair.
The part number is listed by CONSULT-III plus (C-III plus) when performing a Manual Configuration and does
not match the part number that is listed on the module’s external label.

Use the part number listed below (and shown in Figure 1) to configure the CAN Gateway Module for all
trim levels of the Applied Vehicles.
284D2-4GB0B
Figure 1
NOTE: Refer to the Electronic Service Manual (ESM), section LAN – LAN System, for further information.
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe
that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.
1/1