16-001
Service Bulletin Details
Public Details for: 16-001
When replacing a fuel injector on a 4p10 engine, the injector code from the newly installed injector must be programmed into the eec. The injector code is an eight character, alphanumeric code found etched into the plastic at the top of the
- 2017 - 2016 - 2015 - 2014 - 2013 - 2012 -
Models from 2017
2017 MITSUBISHI FUSO FEC52 |
2017 MITSUBISHI FUSO FEC72 |
2017 MITSUBISHI FUSO FEC92 |
2017 MITSUBISHI FUSO FGB72 |
Models from 2016
2016 MITSUBISHI FUSO FEC52 |
2016 MITSUBISHI FUSO FEC72 |
2016 MITSUBISHI FUSO FEC92 |
2016 MITSUBISHI FUSO FGB72 |
Models from 2015
2015 MITSUBISHI FUSO FEC52 |
2015 MITSUBISHI FUSO FEC72 |
2015 MITSUBISHI FUSO FEC92 |
2015 MITSUBISHI FUSO FGB72 |
Models from 2014
2014 MITSUBISHI FUSO FEC52 |
2014 MITSUBISHI FUSO FEC72 |
2014 MITSUBISHI FUSO FEC92 |
2014 MITSUBISHI FUSO FGB72 |
Models from 2013
2013 MITSUBISHI FUSO FEC52 |
2013 MITSUBISHI FUSO FEC72 |
2013 MITSUBISHI FUSO FEC92 |
2013 MITSUBISHI FUSO FGB72 |
Models from 2012
2012 MITSUBISHI FUSO FEC52 |
2012 MITSUBISHI FUSO FEC72 |
2012 MITSUBISHI FUSO FEC92 |
2012 MITSUBISHI FUSO FGB72 |
Service Information Bulletin Group 13 Fuel System Bulletin Number: 16-001 Models: FE/FG Issue Date: March 2016 Page 1 of 1 NOTE: The information contained in this document is intended for use by trained, professional technicians with the knowledge, tools, and equipment to properly and safely perform diagnoses and repairs. It informs service technicians about conditions that may occur in some vehicles, or provides information that could assist in proper vehicle diagnosis, service, or repair, and does not indicate that a defect is present. DO NOT assume that a symptom or condition, or a described cause of a symptom or condition, affects any particular vehicle or that a described repair applies to any particular vehicle. There can be multiple causes resulting in the same symptoms or conditions, and trained professional service technicians must use their diagnostic skills to make evaluations on a case-by-case basis. SUBJECT: 4P10 Injector Programming POTENTIALLY AFFECTED MODELS: 2012 and newer FEC52, FEC72, FEC92, and FGB72 Canter Vehicles DESCRIPTION: When replacing a fuel injector on a 4P10 engine, the injector code from the newly installed injector must be programmed into the EEC. The injector code is an eight character, alphanumeric code found etched into the plastic at the top of the injector, as shown below. When this number is entered into the EEC using the FD Tool, DO NOT include the “D” at the end of the injector code, enter only the first seven characters. If the entire code is entered, an error will be displayed stating that the code is invalid. Please initial and route to the following personnel before filing. Service Mgr. Warranty Mgr. Shop Foreman Parts Mgr. Service Technicians - Initial in boxes below. This Service Information Bulletin is supplied for information purposes only and is not an authorization for any repairs. © Mitsubishi Fuso Truck of America 2016