NTB21-049

Classification:
EC21-008
Reference:
Date:
NTB21-049
June 8, 2021
MIL ON WITH DTC P0101 AND/OR P0507 STORED IN THE ECM
APPLIED VEHICLES:
2018-2021 Kicks (P15)
2020-2021 Versa (N18)
IF YOU CONFIRM
The MIL is ON and DTC P0101 (MAF SENSOR) and/or P0507 (ISC SYSTEM) is stored in
the ECM.
ACTION
1.
Test the vehicle’s 12 volt battery using the Midtronics DSS-5000. Recharge or replace
the battery if necessary.
2.
Erase all DTCs.
3.
Perform Idle Air Volume Learning (IAVL).
IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you
will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it
contains information that is essential to successfully completing this repair.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3
SERVICE PROCEDURE
1.
Test the vehicle’s 12 volt battery using the Midtronics DSS-5000.

The DSS-5000 contains internal operating instructions accessed using its touch
screen.

The DSS-5000 operating instructions are also found at
http://nissan.dss5000.com/. These operating instructions include a Quick Start
Guide and VIN scanning tips.

There is also a SIR video Vol. 551 that demonstrates the use of the DSS-5000.
2.
Recharge or replace the battery if the test result indicates to do so.
3.
Erase all DTCs.
4.
Start the engine and allow it to idle for a minimum of 20 minutes under the following
conditions:

Engine hood closed.

Ambient temperature MUST be above 5°C (40°F).
o If the ambient temperature is lower than 5°C (40°F), move the vehicle inside a
building.
5.

Engine coolant temperature MUST be above 80°C (175°F).

ALL electric accessories MUST be turned off.
Perform the Idle Air Volume Learning (IAVL) using the CONSULT-III.
2/3
NTB21-049
CLAIMS INFORMATION
Submit a Primary Part (PP) type line claim using the following claims coding:
DESCRIPTION
Test & Charge Battery, Erase DTC’s and
Perform IVAL Procedure
(1)
PFP
OP CODE
SYM
DIA
FRT
(1)
DX60AA
ZE
32
0.6
Reference the electronic parts catalog and use the Throttle Chamber (16119-*****) as
the Primary Failed Part (PFP).
OR
If the battery is replaced:
DESCRIPTION
PFP
Test & Charge Battery
(1)
Idle Air Volume Learning Procedure
(2)
SYM
DIA
FRT
ZE
32
(2)
GB18AA
Replace Battery
(1)
OP CODE
GB181A
DE96AA
Reference the electronic parts catalog and use the Throttle Chamber (16119-*****) as
the Primary Failed Part (PFP).
Reference the current Nissan Warranty Flat Rate Manual and use the indicated Flat
Rate Time (FRT).
NOTE: FRT allows adequate time to access DTC codes. No other diagnostic procedures
subsequently required. Do NOT claim any Diagnostic Op Codes with this claim.
AMENDMENT HISTORY
PUBLISHED DATE REFERENCE
June 8, 2021
NTB21-049
DESCRIPTION
Original bulletin published
3/3
NTB21-049