0804314
Service Bulletin Details
Public Details for: 0804314
Cruise control system slow to respond to cruise control switch inputs
- 2014 -
Models from 2014
2014 JEEP WRANGLER |
NUMBER: GROUP: DATE: 08-043-14 Electrical May 02, 2014 This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of Chrysler Group LLC. HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING “HELP” THEN “HELP CONTENTS” AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW. THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 14.03 OR HIGHER TO PERFORM THIS PROCEDURE. SUBJECT: Cruise Control System Slow To Respond To Cruise Control Switch Inputs OVERVIEW: This bulletin involves upgrading the software in the Powertrain Control Module (PCM). MODELS: 2014 (JK) Wrangler (International Only) NOTE: This bulletin applies to vehicles built on or before April 21, 2014 (MDH 0421XX) equipped with Speed Control (sales codes NHM). SYMPTOM/CONDITION: A customer may experience, slow response to cruise control switch activations. DIAGNOSIS: Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in TechCONNECT, verify no DTC's are set. If DTCs are present record them on the repair order and repair as necessary before proceeding further with this bulletin. If the customer describes the symptom, perform the Repair Procedure. REPAIR PROCEDURE: NOTE: Install a battery charger to ensure battery voltage does not drop below 13.2 volts. Do not allow the charging voltage to climb above 13.5 volts during the flash process. NOTE: If this flash process is interrupted/aborted, the flash should be restarted. 08-043-14 -2- 1. Reprogram the PCM with the latest software. Using the wiTECH diagnostic application for flashing an PCM is available by selecting “help” then “help contents” at the top of the wiTECH diagnostic application window. 2. Clear any DTC's that may have been set in all modules due to reprogramming. The wiTECH application will automatically present all DTCs after the flash and allow the tech to clear them. POLICY: Reimbursable within the provisions of the warranty. TIME ALLOWANCE: Labor Operation No: 18-19-04-AJ Description Module, Powertrain Control (PCM) Reprogram (1 Semi-Skilled) FAILURE CODE: FM Flash Module Skill Category Amount 8 - Engine Performance 0.2 Hrs.