15NA051
Service Bulletin Details
Public Details for: 15NA051
No start condition - seat bracket contacting rear electrical center (rec)
Models from 2011
2011 BUICK LUCERNE |
Models from 2010
2010 BUICK LUCERNE |
Models from 2009
2009 BUICK LUCERNE |
Models from 2008
2008 BUICK LUCERNE |
File in Section: Bulletin No.: Service Bulletin Date: 15-NA-051 November, 2015 TECHNICAL Subject: No Start Condition - Seat Bracket Contacting Rear Electrical Center (REC) Brand: Model: Buick Lucerne Model Year: VIN: from to 2008 2011 from Engine: Transmission: All All to Condition Some customers may comment on a no-start or stalling condition. Cause The rear seat bottom frame may come into contact with the rear electrical center (REC) cover. The contact/interface results in varying amounts of deflection of the fuel pump relay (FPR). The movement of the FPR causes potential wear of the male terminals on the FPR. Correction • • Install a low profile fuel pump relay. Remove material from the rear seat bottom frame, driver side mounting brackets. Service Procedure: 1. Open the rear door and remove the rear seat bottom cushion. 2. Disconnect the battery. 3. Remove the fuel pump relay from the rear body fuse block and discard. Refer to Relay Replacement (within an Electrical Center). 4. Install the new low profile fuel pump relay to the rear body fuse block and install the cover. 5. Connect the battery. 4294546 Copyright 2015 General Motors LLC. All Rights Reserved. Page 2 November, 2015 Bulletin No.: 15-NA-051 4294548 6. With the rear seat cushion on a bench, measure 5 mm (0.197 in) from each edge of the right side seat mount bracket and mark with a paint marker as shown (1). 4294550 7. Using a cut off wheel or equivalent, carefully cut each side of the bracket as shown (1). 8. Check for any rough edges and file if necessary. 9. Install the rear seat cushion and close door. Parts Information Description Part Number Low Profile Fuel Pump Relay 88953222 Bulletin No.: 15-NA-051 November, 2015 Page 3 Warranty Information Labor Operation Description Labor Time 5480178* Replace Fuel Pump Relay, and Cut Rear Seat Bracket 0.4 hr *This is a unique Labor Operation for Bulletin use only. Version 1 Modified GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information. WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION