P1289

Aborted KOER - ICP Failure

DTC P1289, sometimes indicated as P128900 is an OBD diagnostic trouble code indicating a manufacturer-specific fault with the vehicle powertrain (i.e. engine and gearbox). This code identifies an error with the air/fuel mixture causing aborted koer - icp failure.

  • P1289: Aborted KOER - ICP Failure

DTC Trouble Code Search
Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • TSB 19-2049 - POWER TRAIN
    FORD: Some 2019 mustang and f-150 vehicles built on or before 8-jan-2019 and equipped with a 5.0l engine may exhibit an illuminated malfunction indicator lamp (mil) with diagnostic trouble codes (dtcs) P1289 and/or P017D stored in the powertrain
  • 04056 - ELECTRICAL SYSTEM
    NISSAN: Malfunction indicator light on with diagnostic trouble codes P1278, P1279, P1288 and P1289 a/f sensor. *mr this bulletin replaces ntb04-056 dated 5/15/2004. *tt
Consumer Complaints for this DTC



2006 FORD ESCAPE with 161487. miles

Wife was driving her 2003 Ford Escape 2.3l xls (fwd, 5-spd manual) at 65mph, practically coasting down a hill. 26 minutes after engine start she heard a loud bang and subsequent popping sounds. This was followed immediately by severe power loss from the engine. She drove it to the next best off-ramp, an additional 2 miles. When she got off the freeway she says she had to rev it up quite a bit to make an intersection to get to the gas station where the car rolled to a stop. That loud bang turned up to be the nbr 3 cylinder blowing its spark plug clean off the spark plug bore. The spark plug bore was completely threadless. The subsequent popping sounds were due to the spark plug not being on the nbr 3 cylinder as the fuel that continued to spray into the cylinder was burning off. The immediate power loss is a direct result of the engine loosing 25% of its chugga-chugga and the loss of the cht sensor signal which both then caused the pcm (powertrain control module) to go into limp mode and further reduce engine power. First thing i did was plug in my obdii scanner and check for codes. I found the following three: P0303 - cylinder 3 three misfire. P0353 - ignition coil 'c' primary/secondary circuit. P1289 - cylinder head temp sensor high input. I then performed a koeo (key-on/engine-off) check with my obdii scanner and found the following two codes: P0119 - engine coolant temperature circuit intermittent/erratic. P1289 - cylinder head temp sensor high input. The cht probe (cylinder head temperature) cover/boot was popped off the engine camshaft cover and the wires were broken off the cht probe electrical connector. The spark plug terminal broke off. The ignition coil pack was severely damaged (looked like an exploded cigar, cartoon style).
ENGINE, ELECTRICAL SYSTEM

Previous Code: P1288 | Next Code: P1290