1995 BMW R1100rslBmw R1100rsl 1995

Vehicle Details: Recalls, Consumer Complaints, Service Bulletins

Below you will find all available information on the 1995 BMW R1100rsl.

ManufacturerKnown WMI(s)Fuel Type
BMW
BMW VIN Decoder

Use the box here to look up VINs from BMW as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 1995 BMW R1100rsl?
     - There are 2 recall(s) for the 1995 BMW R1100rsl, additional information is below.
NHTSA Mandated Recalls
  • Recall 13419 [USA]: If this warning is ignored and the engine is left running at an increased speed above idle while the motorcycle is at a standstill with the air stream required for cooling missing, the exhaust system temperature will rise considerable increasing the risk of a fire.

  • Recall 1997196 [Canada]: Other

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • SB-00-021-07 - FUEL SYSTEM, OTHER: Bmw motorcycle: engine fuels containing ethanol. Bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. Ethanol mixtures in proportions higher than 10%
Most Recent Consumer Complaints and Accidents
CrashFireTowedInjuredDeathsFailure
Date
NoNoN NoneNone20071104

Failure of the large bearing in the final drive assembly. The seal did not leak prior to failure. *tr

NoNoN NoneNone20000531

A number of similar complaints by other bmw riders who have experienced the same problem over the internet site([email protected])has promped this complaint.Thank you for investigating this issue. No safety defect listed in summary. *ak

NoNoN NoneNone19961023

The tires were always inflated at the pressures recommended by the manufacturers. The front wheel would bend because of its three spoke design and the soft allow used. Replacement was originally $600 plus labor and later, the price was dropped to $400 plust labor. The company refused to acknowledge the problem. I have three other motorcycles, using them to travel the same route and have never experienced bent front wheels with any of them. *ak

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.