Chevrolet Impala 1994
Vehicle Details: Recalls, Investigations, Consumer Complaints, Service Bulletins
Use the box here to look up VINs from CHEVROLET as well as other manufacturers
-
Where is the 1994 CHEVROLET Impala produced?
- The 1994 CHEVROLET Impala is produced in Warren Michigan, United States (usa).
-
Are there recalls for the 1994 CHEVROLET Impala?
- There are 1 recall(s) for the 1994 CHEVROLET Impala, additional information is below.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- 130089009 - ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM): Expanded availability for remanufacture and return (r&r) electronic control modules
- 9709016114B - ENGINE AND ENGINE COOLING:ENGINE:GASOLINE: Experiencing engine noise. *yc
- 676114A - ENGINE AND ENGINE COOLING:ENGINE: Engine noise (install valve stem oil seal). *tw
- 776513 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Water in air pump and/or dtc P0410, P0412, P1415, P1416, P0100, P0101, P0102 and dtc 48 (install air pump service kit). *tw
- 533403 - STRUCTURE:FRAME AND MEMBERS: Rear wheel/tire position in wheel well opening. *tw
Coolant fires investigation # EA99003
There is no summary currently available
Crash | Fire | Towed | Injured | Deaths | Failure Date |
---|
No | No | N | None | None | 20080503 |
Instrument panel keeps going out (speedometer,tach,gas,heat) reads 150 mph while i am at a complete stop. I have to turn off the engine and turn the key on and off till it comes back down. And even this does not always work. Now the gauge for the temp. Of the car is reading that it is overheating as soon as i start driving. I have had to take it in to get it checked for several things. The car has only 42,000 miles on it. This has be going on for about a year and is getting worse!! *tr
No | No | N | None | None | 20060601 |
Speedometer and odometer act erratically at times with no warning nor symptoms. *tr
No | No | N | None | None | 20040516 |
Consumer complained about the connector for the fuel pump. Vehicle was equipped with a harness to the fuel pump which burnt. The wires became hot and melted the plastic insulation, causing the pump not to work. *ak
No | No | N | None | None | 20000602 |
Drivers side seatback failure on acceleration from stop nearly causing loss of control of vehicle. Parts that failed were two small very inadequate bolts used to attach seatback to seat base.
No | No | N | None | None | 20000127 |
My husband disassembled the gas tank to get to the fuel pump so he could replace it. The fuel pump is located inside the tank and when he looked and the wiring harness the wires had melted the exterior coating and the plastic fitting that also sit in the gas tank. We feel that this could have ended very tragic with the gas tank catching on fire. I am 5 months pregnant and would like to know if this problem has occurred in the past and if there is some sort of action we can take to keep it from happening again. *ak( dot number: )
No | No | N | None | None | 19990926 |
This part covered under gm recall 94-c-59 but only if it was installed on a veh intented to be used as a police car or taxi cab per dealer. Impala ss is 9c1 option code. Same mechanicaly as police car. Seems like gm should have included it in the recall. This is a safety issue! No safety defect mentioned in summary. *ak
No | No | N | None | None | 19961003 |
Loosened nut on battery cable interfered with high amperage equipment of vehicle. Allowing engine to stall.
No | No | N | None | None | 19960610 |
Air bag indication light stays on which means a malfunction within the air bag system. Dealer contacted and is aware of the problem, trying to remedy the problem. Air bags have not yet deployed. Provide further information. *ak
No | No | N | None | None | 19960604 |
When at a stop the car idles, starts/ surges up and down.*ak
Common OBD-II Error Codes
- P0410 [1] Secondary Air Injection System Malfunction
- P0412 [1] Secondary Air Injection System Switching Valve A Circuit Malfunction
- P0100 [1] Mass or Volume Air Flow "A" Circuit Malfunction
- P0101 [1] Mass or Volume Air Flow "A" Circuit Range/Performance Problem
- P0102 [1] Mass or Volume Air Flow "A" Circuit Low Input
- P1415 [1] EGR Flow Out Of Self Test Range
- P1416 [1] EVR Control Circuit Malfunction