Dodge Stratus 1997

• Recall 84375 [USA]: If there is a separation of the ball stud from the housing, the driver can loose steering control, possibly resulting in a vehicle crash.
  Federal-mogul is recalling certain replacement control arm assemblies, part numbers k7425, 10945, fa4510x, k7427, 10946, and fa4611x, sold for use on various passenger vehicles listed above. The ball joint on the control arm assembly can fail causing the ball stud to wear through the control arm housing resulting in noise and/or separation of the ball stud from the housing.
  federal-mogul will notify owners of record and replace the affected control arms free of charge. The safety recall began on january 28, 2011. Owners may contact federal-mogul at 1-877-489-6659.
  this recall only pertains to replacement control arm assemblies and has no relation to any original equipment installed on vehicles manufactured by chrysler llc.Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

  Show Content

• Recall 68277 [USA]: Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash.
  Qualis automotive is recalling certain aftermarket ball joints sold for use on certain passenger vehicles. The socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. The subject ball joints were sold as four part numbers, d10945, d10946, g10945, and g10946. The affected control arms, d10945 and d10946, are stamped with the following dates on the ball joints: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, and 116609. The g10945 and g10946 are the same part as the d10945 and d10946 respectively. They are labeled differently depending on the aftermarket customer.
  qualis automotive will replace the ball joints free of charge. The safety recall began on november 9, 2009. Owners may contact qualis automotive at 1-800-493-4128.
  this recall only pertains to aftermarket ball joints and has no relation to any original equipment installed on vehicles produced by chrysler.Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

  Show Content

• Recall 37165 [USA]: Fuel restriction could result in loss of power and/or engine stall, possibly resulting in a vehicle crash.
  Certain tigas fuel pump modules manufactured between june 1 and september 24, 2006, sold under various brand names and p/nos. These fuel pump modules are sold as aftermarket for use in certain daimlerchrysler vehicles listed above. Silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.
  ti automotive will notify owners and replace the defective fuel pump modules free of charge. The recall began on october 6, 2006. Owners may contact ti automotive toll-free at 1-877-461-1834.
  this recall only pertains to aftermarket fuel pump modules and has no relation to any original equipment installed on vehicles by daimlerchrysler.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 41973 [USA]: Either circumstance may result in the vehicle rolling away without warning.
  On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.
  dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler at 1-800-853-1403.
  daimlerchrysler recall no. C45.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 14240 [USA]: If this happens, the "ignition-park" interlock system will be nonfunctional.
  Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.
  dealers will inspect for proper operation of the system. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a "self-adjusting" design.
  owner notification began october 26, 1998. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-992-1997.Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 15687 [USA]: Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.
  Vehicle description: passenger vehicles. The lower control arm ball joint can separate due to loss of lubrication.
  dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
  owner notification began december 15, 1997.Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-992-1997.Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

  Show Content

• Recall 12751 [USA]: If this condition occurs simultaneously without engaging the primary latch, the hood would not be restrained increasing the risk of a vehicle crash.
  Vehicle description: passenger vehicles. The secondary hood latch spring can disengage from its retention hole if the hood is slammed shut.
  dealers will replace the secondary hood latch spring with a longer end hook spring.
  owner notification:owner notification began july 14, 1997.Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-853-1403.Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

  Show Content

• Recall 2004003 [Canada]: Other
  On certain vehicles equipped with an automatic transmission and a floor-mounted shifter, the ignition-park interlock may become defeated and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position. This may result in the vehicle rolling away without warning. Correction: dealer will inspect the function of the ignition-park interlock system. Vehicles found with functional interlock systems will have a load-limiting push rod installed into the floor shifter lever. Vehicles with a non-functional ignition-park interlock system will have the shifter assembly replaced.

  Show Content

• Recall 1998165 [Canada]: Other
  Note: vehicles equipped with a floor mounted automatic transmission shift lever. A combination of applying a mis-adjusted shifter release button with a low force attempt to shift out of park with the key in the locked position may break the connecting pin in the shifter. If this happens, the "ignition-park" interlock system will not function. Correction: the console shift interlock mechanism will be inspected for proper function. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a current production "self adjusting" design.

  Show Content

• Recall 1997123 [Canada]: Structure
  The primary/secondary hood latch spring may not remain in position during hood closing, which can result in loss of both the primary and secondary latch function. Loss of hood function can result in a hood fly-up condition. Correction: the secondary hood latch spring will be replaced with one having a longer end hook.

  Show Content

• Recall 1997205 [Canada]: Suspension
  On certain vehicles, the lower control arm ball joint may separate due to loss of lubrication. This separation could result in loss of vehicle control and a crash without prior warning. Correction: ball joint end housing cover seal will be inspected for leakage and the rubber boot will be inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Auto trans ignition-park interlock investigation # EA03011

  The manufacturer reports above are based on daimlerchrysler¿s (dc) analysis of model year (my) 1998 (population = 356,384) and 1999 (population = 486,948) ja, jx and lh family subject vehicle data (earlier mys excluded).The population number includes all mys.The precise number of duplicates between odi and dc reports cannot be determined due to missing or incomplete information.The fatality incident involved an elderly person who attempted to stop a roll away vehicle and received fatal injuries.Odi also gathered information on my 1997-99 prowler vehicles in this investigation. The prowler vehicles were manufactured with a different design shifter mechanism (the shift lever is shorter).There are no complaints of prowler interlock failure in odi¿s database, and dc has received no reports either.The prowler is excluded from the recall scope.The investigation involved a condition where the interlock system could fail (or be made inoperative by the operator) during vehicle use, possibly inadvertently.The interlock system is required under fmvss 114.With the transmission in the park position and the ignition key off, the combined action of pressing the shift button and pulling the shift lever rearward may result in the operator overcoming the interlock system and cause the mechanical linkage of the system to disconnect.When this occurs, there is no overt indication to an operator that the system is defeated, and an increased risk of vehicle roll-away exists.Under recall 04v021, dc will replace damaged shift mechanisms, and will install on all vehicles a device which inhibits the operator¿s ability to overcome the interlock and defeat the system.Beginning with my 2000, dc incorporated a brake and transmission shifter interlock (btsi) system into the subject vehicles.Introduction of btsi involved design changes to the shift mechanism, one of which resulted in reduced mechanical advantage (rma) of the shift button.The rma shifter requires increased forces to overcome the interlock system, making the shifter less susceptible to damage.
  

  Show Content

• Safety belt cinching latch plate investigation # PE02082

  There are no injuries or fatalities associated with this alleged defect.While conducting this investigation, odi found that the subject cinches meet the load bearing requirements of federal motor vehicle safety standard 208, and that many of the reported failures were due to incorrect child safety seat installations. Additionally, the report rate is low (1.60/100k).The information available fails to establish the existence of a defect trend at this time.Further allocation of agency resources to this issue is unwarranted and the preliminary evaluation is being closed.
  

  Show Content

• Lower control arm ball joint failure investigation # EA97016

  By letter dated november 6, 1997, the manufacturer advised this agency of its decision to initiate a safety recall campaign of the subject vehicles to correct the defect identified in this ea.The recall will also cover 1996 and 1997 chrysler cirrus/dodge stratus vehicles, as well as 1995 through 1997 chrysler sebring convertible and plymouth breeze vehicles equipped with identical lower control arm ball joints.An estimated total of 599,00vehicles are affected by this recall.The manufacturers investigation disclosed that process variability, together with the ball joint housing cover crimping operation, can result in an ineffective seal that permits a loss of lubrication and accelerted wear of the ball joint assembly.This condition can lead to failure and separtion of the lower control arm ball joint.The recall is identified as nhtsa 97v-201 and a copy of chryslers letter to nhtsa is attached hereto.
  

  Show Content

Notice a smell from under the hood while driving open the hood fire put the fire out notice power hose had leak in it i feel dodge should be held accountable for this malfunction

Notice a smell from under the hood while driving open the hood fire put the fire out notice power hose had leak in it i feel dodge should be held accountable for this malfunction

Takata recall, horn don`t work, millage don`t work ,gas light comes on and neddle moves up and down alot

Either the oil light or cruise light will come on and car loses all power. I have to pull off road and put car in park turn it off and sometimes it will just start right back and sometimes i have to wait for about 30 mins for it to start back. I have only had the car since march of 2013 and it has done this 10-12 times since then. I almost got rear ended a few times cause with no power it is hard to get car off the road. I have contacted dodge but there is no recall for this problem yet. *tr

Tl* the contact owns a 1997 dodge stratus. The contact stated that the fuel filler hose was loose and would not keep fuel in the vehicle. The vehicle was not inspected by a dealer nor repaired. The manufacturer was contacted and they offered no assistance. The failure and current mileages were approximately 168,000.

Tl*the contact owns a 1997 dodge stratus. The power steering high pressure hose was leaking into the engine. The 2.4 liter engine had a leak directly above the exhaust system. The vehicle was not taken to the dealer. The manufacturer was called and informed him that there were no recalls or warranties for the failure. The failure mileage was 147,000.

Car was sitting front of my daughter's house and it caught fire under the hood on the driver's side. Car was totally destroyed. *tr

Loss of power and stalling. While on hills it has no power on me shuts off on me every week. Said that i had to pay for fixing that dodge dealer isn't responsible for charges. *tr

Tl*the contact owns a 1997 dodge stratus. While driving approximately 45-50 mph on normal road conditions, the cruise control was activated. When the contact depressed the brake pedal, the cruise control failed to deactivate. He made several attempts to disengage the cruise control mechanism, but was unsuccessful. The gear shifter was placed into neutral and the vehicle suddenly began to slow down; however, the engine revved highly. The vehicle has not been repaired. The failure occurred whenever the cruise control was activated and the vehicle was in motion. The failure mileage was 150,000 and current mileage was 175,000.

Common OBD-II Error Codes

• P0442 [1] Evaporative Emission Control System Leak Detected (small leak)
• P0455 [1] Evaporative Emission Control System Leak Detected (gross leak)
• P0456 [1] Evaporative Emissions System Small Leak Detected
• P1494 [1] EGRCHK Solenoid Circuit Malfunction