2012 HINO Ne8jHino Ne8j 2012

Vehicle Details: Recalls, Service Bulletins

Below you will find all available information on the 2012 HINO Ne8j.

ManufacturerKnown WMI(s)Fuel Type
HINO
HINO VIN Decoder

Use the box here to look up VINs from HINO as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 2012 HINO Ne8j?
     - There are 8 recall(s) for the 2012 HINO Ne8j, additional information is below.
NHTSA Mandated Recalls
  • Recall 134827 [USA]: Excessive wear of the cylinders can result in engine failure, increasing the risk of a crash.

  • Recall 110364 [USA]: Either parking brake condition may result in the vehicle rolling unexpectedly, increasing the risk of a crash.

  • Recall 92189 [USA]: If the b+ circuit shorts to ground, it may lead to a fire.

  • Recall 77018 [USA]: Insufficient torque of the steering arm bolts may result in bolt fatigue and fracture and/or arm separation, thereby potentially resulting in loss of steering control, increasing the risk of a crash.

  • Recall 76783 [USA]: The wheel-hub and axle shaft can separate from the vehicle, possibly resulting in a crash.

  • Recall 79481 [USA]: Without heat treating, a bearing may suffer pre-mature failure which may result in a fire at the wheel or wheel separation that could lead to a crash.

  • Recall 2014032 [Canada]: Brakes

  • Recall 2013435 [Canada]: Brakes

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • TT-14-033 - ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION: When replacing an engine block with service part no., 11401e0380 there is potential that 2 rear oil passage plugs may be missing in the rear of the replacement engine block. In the event your replacement engine block does not have these 2 o
  • SB-14-020 - STRUCTURE:BODY:HOOD:HINGE AND ATTACHMENTS: When replacing a broken hood grille, an enhanced replacement hood grille is available. This procedure should be used when installing this enhanced grille to make certain that the hood grille is correctly installed.
  • SB-14-016 - POWER TRAIN: In the event that one of the subject vehicles is driven while the abs warning lamp is illuminated, operation of the torque converter clutch will be suspended. Driving the vehicle with an abs warning lamp illuminated can lead to overheating
  • SB-14-014 - EQUIPMENT: Subject vehicles may exhibit a concern where manual regeneration does not complete within one hour of depressing the manual regeneration button. In these cases, there will be no indicators showing why manual regeneration will not complete.
  • SB-14-013 - ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE: Dpr damage, "burner misfire due to excessive soot on the burner igniter surface", and "dpr push out" may occur due to the increase in the amount of soot in exhaust gas as a result of engine component degradation. In order to reduce the soot
  • 14-002 - EQUIPMENT: Coe hybrid safety equipment, tools and practices
  • TSB-14-025 - EQUIPMENT: Subject vehicles may exhibit electrical symptoms which can include, but are not limited to erratic operation of the exterior lamps, warning lamps illuminated in the instrument cluster, or erroneous dtc?S (diagnostic trouble codes) setting i
  • RCB-003-15 - PARKING BRAKE: If the parking brake is not released in accordance with the instructions in the driver?S/owner?S manual (such as releasing the parking brake lever only by pushing the lever release button, without holding the lever with the hand, until it i
  • SB-15-010 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE): Some vehicles that operate in extreme cold weather climates may exhibit ice accumulation on the egr (exhaust gas recirculation) butterfly plate with a repeat P1604 dtc (diagnostic trouble code) stored in the engine ecu. A heated egr valve h
  • HINO 12-003 TT - ELECTRICAL SYSTEM: This tech tip pertains to 2012 ne8j, nj8j, nv8j models that have ecu software 89663-e2b40a or 89663-e2b50a. Some engines may erroneously record P2457 dtc in ecu. This fault condition is due to ecu software misdetection of egr cooler effi
  • HINO 12-004 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Subject vehicles:
  • 167-T1514-12 - STRUCTURE:BODY: Tt-15-016 the purpose of this publication is to communicate the standard measuring positions on the hino chassis. In some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards t
  • 167-T1513-12 - POWER TRAIN: Tt-15-014 the transmission dtc?S P0974 and P0986, may be found on 12my-15my coe models. There could also be a complaint of low power and erratic shifting. These diagnostic codes may be set due to low voltage between the transmission case an
  • 167-T0706-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : 07 - 006 voltage drop test
  • 167-B1312-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-13-009 this bulletin is to inform dealers and workshops of proper paint codes for all hino models. All models
  • 167-B1307-12 - POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL): 13-008 design change of the idler gear case and idler gear bolt. Abnormal load such as a stuck supply pump was applied to gear train then causing the bolt to loosen. Therefore, an enhancement to the case and bolt were carried out. The idle
  • 167-B1301-12 - PARKING BRAKE: Sb-13-003 in some cases the parking brake lamp indicator may remain illuminated with the parking brake lever in the ?Off? Position. This tsb (technical service bulletin) will provide instructions for installing an enhanced parking brake swi
  • 167-B1101-12 - FUEL SYSTEM, OTHER: Sb-11-002 requirements of biofuel usage for 2008my thru 2012my vehicles all applied models
  • 167-B1625-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-16-021 correction of workshop manual for hino600 series correction of electrical wiring diagram
  • 167-B1621-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-16-010 correction of the inspection of the dpr filter.
  • 167-B1529-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-15-032 troubleshooting information and inspection procedure of the dtc/P2030 were revised.
  • 167-B1528-12 - EQUIPMENT:ELECTRICAL: Sb-15-031 foreign debris in the def (diesel exhaust fluid) tank may cause the scr (selective catalyst reduction) system to malfunction. This can result in dtc?S (diagnostic trouble codes) P20E8 or P20E9 - def pressure abnormality. An inlet
  • 167-B1523-12 - ENGINE AND ENGINE COOLING: Sb-15-026 a subject vehicle may exhibit an engine oil leak or engine coolant leaking externally from the engine head gasket sealing area on the exhaust manifold side of the engine. An improved head gasket has been made available as a servic
  • 167-B1521-12 - SUSPENSION: Sb-15-022 in the rare event that a subject vehicle equipped with the 23k comfort ride air suspension experiences a premature main leaf failure, a 23k hd comfort ride air suspension may be installed with prior approval from hmm qa.
  • 167-B1511-12 - STEERING: STEERING WHEEL/HANDLE BAR: Sb-15-011 the following tsb (technical service bulletin) outlines the inspection method for steering wheel free play and the adjustment procedure of the steering gear.
  • 167-B1510-12 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE): Sb-15-010 some vehicles that operate in extreme cold weather climates may exhibit ice accumulation on the egr (exhaust gas recirculation) butterfly plate with a repeat P1604 dtc (diagnostic trouble code) stored in the engine ecu. A heated e
  • 167-B1504-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-15-003 correction of workshop manual for hino 2015my (revision of troubleshooting procedure for the dtc P0421)
  • 167-B1503-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-15-002 correction of workshop manual for 2013 - 2015my (revision of troubleshooting procedure for the dtc P2123)
  • 167-B1415-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb-14-003 the following is to inform you of the revision of the inspection procedure for the dtc?S P0340 and P0341. You are kindly requested to attach this service data to the relevant pages of the workshop manuals for maintenance and to us
  • 167-B1426-12 - STRUCTURE:BODY:HOOD:HINGE AND ATTACHMENTS: Sa-14-026 the broken hood grille procedure (sb-14-020) has been revised to reuse the grille nuts (sz17906009) if possible. There is a limited quantity of the nuts available and it has been confirmed that the nuts are reusable. The revised p
  • 167-B1423-12 - EQUIPMENT:ELECTRICAL: Sb-14-005 2011my-2015my conventional keyless entry programming
  • 167-B1423-12 - ELECTRICAL SYSTEM:SOFTWARE: Sb-14-005 2011my-2015my conventional keyless entry programming
  • 167-T1303-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : 13-003 injection quantity test 11 thru 14my
  • 167-T1204-12 - ENGINE AND ENGINE COOLING:COOLING SYSTEM: 12 - 002 diagnosis procedure for P2457. Some engines may erroneously record a P2457 dtc in the ecu. This fault condition is due to ecu software misdetection of egr cooler efficiency.
  • 167-T1202-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : 12-001 recording the burner event log (bel) on 11-13my trucks
  • 167-B0803-12 - WHEELS:LUGS/NUTS/BOLTS: Sb - 08 - 005 this document is to inform dealers and workshops of the design change to the hood damper, support bolt and the addition of a support collar.
  • 167-B0602-12 - ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER: Sb ? 06 - 002 fuel filter usage. This bulletin provides technical information for proper fuel filter usage as well as an example of damage caused by foreign material allowed to enter the fuel system as a result of using an improper fuel fil
  • 167-B0601-12 - ENGINE AND ENGINE COOLING: Sb ? 06 - 001 design change of engine oil cooler housing. The casting for the engine oil cooler housing has been revised to include 2 shallow machined grooves on both sides of the engine oil cooler housing. These grooves aid in the retentio
  • 167-B0508-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb - 05 - 005 proper maintenance procedures for grease lubricated front axles
  • 167-B0506-12 - ENGINE (PWS): Sb ? 05 - 008 this document is to inform the dealers about the addition of the pressure sensor cover and related part for the j08e engine.
  • 167-B0505-12 - EQUIPMENT ADAPTIVE/MOBILITY: Sb ? 05 - 007 design change of water pipe for j08e
  • 167-B0504-12 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Sb - 05 - 003 this document is to inform dealers and workshops on procedures to activate exhaust brake operation.
  • 167-B0503-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Sb ? 05 - 010 correction to workshop manuals for the j08e engine. A) resistance between terminals of the air intake pre-heater relay should be 64.0 ? 96.0 ohms b) illustration of the air intake pre-heater terminal should be revised. C) r
  • 167-B0502-12 - ELECTRICAL SYSTEM: Sb - 05 - 004 speedometer recalibration. This document is to inform of the procedure to calibrate the pulse adjust module whenneeded (ex. Tire size change, rear carrier ratio change).
  • 167-B0501-12 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : 05 - 011 corrections to workshop manuals for j08 engines. The standard gap between ends of the second piston ring and the oil ring.
  • 167-P1602-12 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP: 13-008 injection pump drive case. Please note the following part number changes to the injection pump bearing case. Not replacing the correct replacement parts will result in major engine damage. The hino ordering system has been modified
  • RCB-001-13 - ENGINE AND ENGINE COOLING:ENGINE:DIESEL: Hino: soot accumulates on the igniter. Burner ignition could perform improperly. Replacement of the diesel particulate regeneration (dpr) igniter plugs. *kb
  • RCB-009-12 - ELECTRICAL SYSTEM:SOFTWARE: Hino: software update for burner control unit (bcu). Ignition of the burner system may perform improperly and cause a mil light to illuminate in the instrument cluster. *kb
  • RCB-008-12 - ELECTRICAL SYSTEM:SOFTWARE: Hino trucks: malfunction indicator lamp (mil) possibly illuminating during cold temperatures. Software update for the dosing control unit (dcu) could solve this problem. *kb
  • RCB-002-13 - ELECTRICAL SYSTEM:SOFTWARE: Hino trucks: malfunction indicator lamp (mil) may be illuminating. Vehicle may also experience reduced power. Performing a software enhancement should correct this problem. *kb

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.