Kenworth K370 2012
Vehicle Details: Recalls, Service Bulletins
Use the box here to look up VINs from KENWORTH as well as other manufacturers
-
Where is the 2012 KENWORTH K370 produced?
- The 2012 KENWORTH K370 is produced in Kirkland Wa, United States (usa).
-
Are there recalls for the 2012 KENWORTH K370?
- There are 5 recall(s) for the 2012 KENWORTH K370, additional information is below.
Recall 126466 [USA]: If the sway bar link detaches and falls into the drag link, it may impact the ability of the vehicle to steer properly, increasing the risk of a crash.
Recall 92092 [USA]: Vehicles that use a combination of both fog lights and head lights or daytime running lights and headlights may be too bright for oncoming traffic, possibly distracting them and increasing the risk of a crash.
Recall 2017432 [Canada]: Suspension
Recall 2012343 [Canada]: Brakes
Recall 2012336 [Canada]: Lights and instruments
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- 02-160 - EQUIPMENT ADAPTIVE/MOBILITY: Information only a?? Windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
- 26-037 - POWER TRAIN: Fix-as-fail - prior versions of eaton endurant transmission software may be prone to setting linear clutch actuator (lca) fault codes leading to possible lca hardware replacement.
- 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
- 34-085 - VEHICLE SPEED CONTROL: Information only a?? Vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
- 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
- 03-071 - ELECTRICAL SYSTEM:SOFTWARE: Information only - vehicles built with namux software from 2013 to present may experience accuracy issues with the tachometer. The issue can be temporarily resolved using any one of the included procedures.
- 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
- TIB43-062 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Information only â¿¿ this bulletin provides information about the california air resources board (carb) periodic smoke inspection program (psip) and heavy duty vehicle inspection program (hdvip).
- 99-035 - ELECTRICAL SYSTEM:SOFTWARE: Information only: notification that davie4 can be used to program model 210 and model 220 vehicles.
- TIB-27-003 - POWER TRAIN:AUTOMATIC TRANSMISSION: Kenworth: see document search button for owner letter. Due to the length of the dipstick (too long), being incorrect, in some trucks/chassis, it fails to give an inaccurate reading for fluid level in the transmission. Models 2012 k270,
- TIB-45-046 - ELECTRICAL SYSTEM:WIRING: Kenworth: see document search button for owner letter. The wires for the temperature and barometric pressure (tbap) sensor harness, may be expose to chafing or rubbing on chassis, and would need to be inspected. Models 2012 k270, 370,
- TIB-14-023 - ENGINE AND ENGINE COOLING:ENGINE:DIESEL: Kenworth: on some manufactured chassis, the clearance between frame rail and charge air cooler pipe may be inadequate and condition needs to be inspected and corrected, if required. Models 2011-2012 k270, k370.
- TIB-52-021 - ELECTRICAL SYSTEM:WIRING:INTERIOR/UNDER DASH: Kenworth: certain chassis were manufactured, incorrectly, with cab power outlet and cable coil, under dash. Models 2011-2012 k270, k370. *pe