Peterbilt 220 2013
Vehicle Details: Recalls, Service Bulletins
Use the box here to look up VINs from PETERBILT as well as other manufacturers
-
Where is the 2013 PETERBILT 220 produced?
- The 2013 PETERBILT 220 is produced in Denton Tx, United States (usa).
-
Are there recalls for the 2013 PETERBILT 220?
- There are 9 recall(s) for the 2013 PETERBILT 220, additional information is below.
Recall 126461 [USA]: If the sway bar link detaches and falls into the drag link, it may impact the ability of the vehicle to steer properly, increasing the risk of a crash.
Recall 104994 [USA]: An unexpected engine shut down increases the risk of a crash.
Recall 101098 [USA]: If the potting compound is exposed to heat and conducts electricity, there is an increased risk of a vehicle fire and personal injury.
Recall 92087 [USA]: Vehicles that use a combination of both fog lights and head lights or daytime running lights and headlights may be too bright for oncoming traffic, possibly distracting them and increasing the risk of a crash.
Recall 2017432 [Canada]: Suspension
Recall 2014305 [Canada]: Electrical
Recall 2014021 [Canada]: Electrical
Recall 2013064 [Canada]: Other
Recall 2012336 [Canada]: Lights and instruments
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- 02-160 - EQUIPMENT ADAPTIVE/MOBILITY: Information only a?? Windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
- 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
- 43-067 - STRUCTURE: Fix as fail: for all conventional models, except 387/587, equipped with side-of-cab (a??Soca??) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the soc exhaust stacks may not be tightened properly. This may allow the
- 11-001 - POWER TRAIN: Information only: hendrickson softek front axle maintenance intervals and requirements.
- 34-085 - VEHICLE SPEED CONTROL: Information only a?? Vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
- 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
- 34-085 - VEHICLE SPEED CONTROL: Information only: vehicles may have the connector seal on the wheel speed sensor incorrectly installed, which may lead to sensor corrosion.
- 03-071 - ELECTRICAL SYSTEM:SOFTWARE: Information only - vehicles built with namux software from 2013 to present may experience accuracy issues with the tachometer. The issue can be temporarily resolved using any one of the included procedures.
- 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
- TIB43-062 - EQUIPMENT: Information only ??A?A? This bulletin provides information about the california air resources board (carb) periodic smoke inspection program (psip) and heavy duty vehicle inspection program (hdvip).
- 42-058 - ENGINE AND ENGINE COOLING: Fix-as-fail: two separate causes have been identified as root cause of intermittent low coolant indicator illumination.
- 34-066 - ELECTRICAL SYSTEM: Information only - quick reference guide for electric harness damage repairs.
- 99-035 - ENGINE (PWS): Information only: notification that davie4 can be used to program model 210 and model 220 vehicles.
- 34-077 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Information only: proper instructions for closure of power distribution box cover to prevent corrosion.
- 13-049 - ELECTRICAL SYSTEM:SOFTWARE: Information: bendix acom software version 6.16.5.0 for diagnostics may introduce an unrecoverable error. Notice to dealers to replace this version with older software version until bendix introduces new version.
- 03-064 - ELECTRICAL SYSTEM: Information - recommended practices for updating esa software
- SB-E-097 - ELECTRICAL SYSTEM:SOFTWARE: Peterbilt: the malfunction indicator lamp (mil) illuminates due to an engine control unit (ecu) software issue, rear nox sensor, operating correctly. *pe
- SB-14-13 - EQUIPMENT ADAPTIVE/MOBILITY: Peterbilt: transition plan available for davie4 diagnostic tool for certain trucks. Models 220, 210. *pe
- RN-413-4 - ENGINE (PWS): Peterbilt: to retain constant power to engine ecm, jumpers bC11211 and 092-5617, have been installed on certain epa model trucks. Model 2013 210, 220. *pe
- RN-413-3 - EQUIPMENT: Peterbilt: information provided regarding the frame rail and charge air cooler pipe and the clearance between that is inadequate and to inspect and if necessary correct condition. Model 210/220. No model years listed. *pe