Spartan K1 2021

Vehicle Details: Recalls, Service Bulletins

Below you will find all available information on the 2021 SPARTAN K1.

ManufacturerKnown WMI(s)Fuel Type
SPARTAN
SPARTAN VIN Decoder

Use the box here to look up VINs from SPARTAN as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 2021 SPARTAN K1?
     - There are 3 recall(s) for the 2021 SPARTAN K1, additional information is below.
NHTSA Mandated Recalls
  • Recall 188856 [USA]: Loose or broken suspension fasteners can allow the rear-drive axle to shift out of place, increasing the risk of a crash.

  • Recall 231299 [USA]: A blank instrument cluster display may be missing critical information such as the vehicle's speed and warning lights, which can increase the risk of a crash.

  • Recall 191192 [USA]: Disengagement of the steering output shaft could result in a loss of steering, increasing the risk of a crash.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • TSB23-540-001 - INTERIOR LIGHTING: This service bulletin is about certain vehicles equipped with 92 inch or longer roof mounted light bars that could experience fracture of the light bar mounting brackets, as well as provides instructions to replace the light bar bracket wit
  • TSB23-260-001 - STEERING: This service bulletin is about the power steering fluid level sensor could exhibit leaks where sensor seals against power steering reservoir and provides instructions on replacing current power steering level sensor with improved sensor des
  • TSB23-520-001A - ELECTRICAL SYSTEM: This service bulletin provides instructions to inspect and rewire 120v box in accordance with diagram. Revision to the previous bulletin released.
  • CSB21-360-001 - TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS: This service bulletin describes the process to remove and replace the control module for the tire pressure monitoring system that was originally equipped with a non-required resistor that may cause disruption to electronics on the body side

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.