Subaru Gl 1980

• Recall 24005 [USA]: The corrosion could affect the operation and control of the vehicle.
  Continuous exposure to road salt could cause corrosion of rear suspension components, especially the inner arms.
  rust proof or replace rear suspension, as necessary.
  system: rear suspension.Vehicle description: front wheel drive passenger cars.

  Show Content

• Recall 1990080 [Canada]: Suspension
  On certain vehicles, continuous exposure to road salt and chemicals may cause corrosion of the rear suspension components, especially inner arms which could affect the operation and control of the vehicle. Correction: rear suspension will be inspected and rust proofed or replaced. Note: recall applies to vehicles in ontario, quebec, new brunswick, nova scotia, prince edward island and newfoundland.

  Show Content

• Recall 1986080 [Canada]: Other
  Certain vehicles do not comply with cmvss 1101(5)(b)(ii) - fuel warning label.

  Show Content

• Recall 1984038 [Canada]: Steering
  The steering rack protective boot can become dislodged when it becomes rigid or inflexible due to extreme cold temperatures and can slip off the retaining groove of the steering housing. This would subject the steering rack shaft to corrosion in areas of high road salt use and result in stiff or hard steering with eventual steering rack seizure. All models except brat models.

  Show Content

• Recall 1983011 [Canada]: Seats and restraints
  Certain 1980 standard, dl, gl, and glf models. There is a potential for the driver's seat backrest frame to distort and eventually break at the mid-upper portion of the backrest frame.

  Show Content

• Recall 1983020 [Canada]: Electrical
  Certain 1980-81 standard, dl, gl, glf models. There is a potential for the 25 amp headlight fuse to overheat, causing the fusible strip to melt resulting in loss of headlight use.

  Show Content

• Recall 1980094 [Canada]: Visual system
  If the windshield wiper motor is switched on when the wiper blades are frozen to the windshield, the drive link connecting the wiper pivot may become bent. This condition may cause the plastic bearing which fits over the drive motor ball joint to pull off thus disengaging the windshield wiper system. Models gl,glf,standard,and dl.

  Show Content

• Recall 1980159 [Canada]: Seats and restraints
  Front seat belt assemblies manufactured by nsk warner ltd.(models nsb 1020-1022) may become unlatched under high belt loads such as experienced in a collision. Model gl only.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Trailing arm corrosion investigation # PE90055

  There is no summary currently available
  

  Show Content