14-BD-002

Service Bulletin Details

Public Details for: 14-BD-002

Summary to be provided on a future date.


- 2013 - 2012 - 2011 - 2010 - 2009 -

,·
@> HVUnDRI I
GROUP
nEWTHlnKlnG.
nEW POSSIBILITIES.
Technical Service Bulletin
SUBJECT:
NUMBER
14-BD-002
BODY
DATE
MARCH 2014
MODEL(S)
GENESIS SEDAN (BH)
INTERMITIENT DOOR LOCK OPERATION
Description:
Certain Genesis Sedan (BH) vehicles may exhibit intermittent unlocking operation of the power door
locks . If this condition is found , follow the inspection and repair procedure described below.
Applicable Vehicles: 2009-2014MY Genesis Sedan (BH) vehicles.
Warranty Information:
Normal warranty applies.
Circulate To : General Manager, Service Manager, Parts Manager, Warranty Manager, Service
Advisors , Technicians , Body Shop Manager, Fleet Repair
SUBJECT:
INTERMITTENT DOOR LOCK OPERATION
Inspection Procedure:
Visually inspect the clearance between the door lock lever and the cap cove r.
Doo r lock lever with proper clearance
If the door lock lever has little or no clearance , or is jamming against the cap cover, proceed to the
repair procedure described below.
Service Procedure:
1. Using a flathead screwdriver, carefully pry the
door handle cap cover off.
Use care to avoid damaging
the door panel.
2 . Loosen the screw located beneath the cap
cover.
Do not remove the screw.
TSB #: 14-BD-002
Page 2 of 4
SUBJECT:
INTERMITTENT DOOR LOCK OPERATl ON
3. Using a flathead screwdriver, carefully remove
the armrest liner.
Use care to avoid damaging
the door panel.
4. Loosen the screw located under the armrest
liner.
Do not remove the screw.
5. To adjust the door lock lever clearance , push
the door panel away from the door hinge in the
direction shown.
Use gloves when adjusting
door panel to avoid
tarnishing door panel trim.
TSB # : 14-BD-002
Page 3 of 4
SUBJECT:
INTERMITIENTDOOR LOCK OPERATION
6. Adjust the door panel until there is a gap of at
least 1mm between the door lock lever and the
cap cover.
7. Retighten the screws and install the door
handle cap cover and armrest liner.
8. Operate the door locks to ensure the cap cover
allows clearance for the lock lever to function
properly.
TSB # : 14-BD-002
Page 4 of 4


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.