JTB00436NAS2

10/5/2015
JTB00436NAS2 - DMTL Pump Water/Ice Ingress | TOPIx
TECHNICAL BULLETIN
JTB00436NAS2
29 SEP 2015
© Jaguar Land Rover N orth A meric a, LLC
N O T E : T he information in T ec hnic al Bulletins is intended for us e by trained, profes s ional T ec hnic ians with the knowledge,
tools , and equipment required to do the job properly and s afely. I t informs thes e T ec hnic ians of c onditions that may oc c ur
on s ome vehic les , or provides information that c ould as s is t in proper vehic le s ervic e. T he proc edures s hould not be
performed by 'do-it-yours elfers '. I f you are not a Retailer, do not as s ume that a c ondition des c ribed affec ts your vehic le.
C ontac t an authorized Jaguar s ervic e fac ility to determine whether this bulletin applies to a s pec ific vehic le.
This reissue replaces all prev ious v ersions. Please destroy all prev ious v ersions.
C hanges are highlighted in gray
SECTION: 310-00
DMTL Pump Water/Ice Ingress
AFFECTED VEHICLE RANGE:
XJ Range (X351)
Model Year:
2010-2015
VIN:
V00001-V90865
Manufacturing
C astle Bromwich
Plant:
Engine:
V6 S/C 3.0L Petrol
V8 5.0L Petrol
V8 S/C 5.0L Petrol
MARKETS:
USA
CONDITION SUMMARY:
Situation: The engine Malfunction Indicator Lamp (MIL) may be illuminated. Upon diagnosis, the technician
may find one or more of the following Diagnostic Trouble C odes (DTC ) stored in the Engine C ontrol Module
(EC M): P043E-00, P0442-00, P0447-00, P0496-00, P2401-00, P2402-00, P2403-00, P2404-00, P2406-00,
P2407-00, P240A-00, P240C -00, and/or P240C -85.
Cause: This may be caused by water/ice, caused by spray from the road tires, becoming trapped within
the Diagnostic Module Tank Leakage (DMTL) pump filter.
Action: Should a customer express this concern, follow the Service Instruction below.
PARTS:
C 2D40532
Evaporative emission canister
Quantity: 1
C 2D30506
Fuel tank filler pipe
Quantity: 1
C 2D49253
Protective Foam
Quantity: 1
TOOLS:
SDD with latest DVD and C alibration File
Jaguar Land Rover-approved Midtronics battery power supply
WARRANTY:
NOTE: Repair procedures are under constant rev iew, and therefore times are subject to
change; those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the
latest repair time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the
causal part number with a quantity of zero.
DESCRIPTION
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
Fuel tank filler pipe - Renew - 3.0L SC V6
19.55.33
1.5
42
C 2C 39518
http://topix.jaguar.jlrext.com/topix/service/document/578168
1/4
10/5/2015
JTB00436NAS2 - DMTL Pump Water/Ice Ingress | TOPIx
Evaporative emission canister - Renew - 3.0L
SC V6
17.15.13
2.6
42
C 2C 39518
Evaporative emission canister - Renew - 5.0L
NA/SC V8
17.15.13
1.9
42
C 2C 39518
Fuel tank filler pipe - Renew - 5.0L NA/SC V8
19.55.33
1.3
42
C 2C 39518
Install the protective foam
05.10.10
0.1
42
C 2C 39518
NOTE: Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1
NOTE: one or both of the following must be v erified.
Prior to replacing any components, verify one or both of the following:
Diagnostic Module Tank Leakage (DMTL) pump failure
Blocked 'Atmospheric vent pipe - DMTL pump to filter' due to debris breaching the 'DMTL (diagnostic
module - tank leakage) filter'
2Install a new fuel tank filler pipe; (see TOPIx Workshop Manual section 310-01B / -C : Fuel Tank and Lines
) follow Steps 1-11.
3Install a new evaporative emission canister, (see TOPIx Workshop Manual section 303-13A / -B:
Evaporative Emissions).
4Install the protective foam in the area shown.
5Make sure the protective foam is installed in the
correct area.
http://topix.jaguar.jlrext.com/topix/service/document/578168
2/4
10/5/2015
6
JTB00436NAS2 - DMTL Pump Water/Ice Ingress | TOPIx
NOTE: the cable tie is supplied installed
through the protectiv e foam.
Secure the protective foam to the metal pipe with
the supplied cable tie.
7Install the rear wheel arch liner.
Torque: 3Nm
8Install the rear wheel.
Torque: 128Nm
http://topix.jaguar.jlrext.com/topix/service/document/578168
3/4
10/5/2015
JTB00436NAS2 - DMTL Pump Water/Ice Ingress | TOPIx
CAUTION: a Jaguar Land Rov er-approv ed Midtronics battery power supply must be connected
to the v ehicle battery during SDD diagnosis / module programming.
CAUTION: ensure all ignition 'ON' / ignition 'OF F ' requests are carried out; failure to perform
these steps may cause damage to control modules in the v ehicle.
9C onnect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle battery.
10Turn ignition 'ON' (engine not running).
11C onnect the Symptom Driven Diagnostics (SDD) system to the vehicle and begin a new session.
12Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle and initiating the
data collect sequence.
13Read and clear the DTC s.
14Follow all on-screen instructions to complete this task, ensuring all DTC s are cleared.
15Exit the current session.
16Disconnect the SDD and the battery power supply from the vehicle.
http://topix.jaguar.jlrext.com/topix/service/document/578168
4/4