Service Bulletin
Service Bulletin Details
Public Details for: Service Bulletin
Service bulletin - there is a screech or squeak when the windows are raised or lowered. The lower seal on the door glass outer weatherstrip rolls over, causing a screech or squeak.
- 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 -
Models from 2013
2013 ACURA MDX |
Models from 2012
2012 ACURA MDX |
Models from 2011
2011 ACURA MDX |
Models from 2010
2010 ACURA MDX |
Models from 2009
2009 ACURA MDX |
Models from 2008
2008 ACURA MDX |
Models from 2007
2007 ACURA MDX |
Service Bulletin 14-043 February 12, 2015 00288-01494 Version 2 Screech or Squeak When the Windows Are Raised or Lowered Supersedes 14-043, dated October 31, 2014, to revise the information highlighted in yellow AFFECTED VEHICLES Year 2007–13 Model MDX Trim ALL VIN Range ALL REVISON SUMMARY Under WARRANTY CLAIM INFORMATION, Labor Operation Number was updated. SYMPTOM There is a screech or squeak when the windows are raised or lowered. POSSIBLE CAUSES The lower seal on the door glass outer weatherstrip rolls over, causing a screech or squeak. CORRECTIVE ACTION Remove the lower seal from each of the four door glass outer weatherstrips. WARRANTY CLAIM INFORMATION The normal warranty applies. Operation Number Description Flat Rate Time Template ID Failed Part Number 8260B7 Remove the lower seal from the four door glass outer weatherstrips. 0.4 hr 14-043A 72410-STX-A11 Defect Code: 00401 Symptom Code: 04219 Skill Level: Repair Technician CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an authorized Acura automobile dealer. © 2015 American Honda Motor Co., Inc. – All Rights Reserved Page 1 of 3 REPAIR PROCEDURE 1. Lower all four windows. 2. Remove the screw(s) attaching the door glass outer weatherstrip. NOTE: The front doors have one screw and the rear doors have two screws attaching the outer weatherstrip moldings. 3. Starting at the rear, pull up on the door glass outer weatherstrip at each area where the inner molding catches the inside edge of the window slot. Page 2 of 3 4. Lift the rear part of the door glass outer weatherstrip away from the door, then pull the front end of it out from under the power mirror. NOTE: Front door is shown; rear door is similar. 5. Using a utility knife, remove the entire lower seal from the molding. 6. Reinstall the outer door glass weatherstrip. 7. Repeat steps 2 thru 6 for the other outer door glass weatherstrips. END. Page 3 of 3