NTB16-119

Service Bulletin Details

Public Details for: NTB16-119

2013 ? 2016 altima; rust around rear license lamp finisher if you confirm when rust is found on the rear deck lid surface in the area surrounding the license lamp finisher (figure 1) or replacing the license lamp finisher for any reason


- 2016 - 2015 - 2014 - 2013 -

Models from 2016
2016 NISSAN ALTIMA
Models from 2015
2015 NISSAN ALTIMA
Models from 2014
2014 NISSAN ALTIMA
Models from 2013
2013 NISSAN ALTIMA
Classification:
Reference:
EL16-020
Date:
NTB16-119
December 1, 2016
2013 – 2016 ALTIMA;
RUST AROUND REAR LICENSE LAMP FINISHER
APPLIED VEHICLE: 2013 – 2016 Altima (L33)
IF YOU CONFIRM
When rust is found on the rear deck lid surface in the area surrounding the license lamp
finisher (Figure 1) or replacing the license lamp finisher for any reason.
ACTION

Replace the license lamp finisher with the new replacement part listed in the Parts
Information.
 Refer to the Electronic Service Manual (ESM), section EXT – Exterior for
removal and installation information.

Repair any damaged surfaces that were in direct contact with the license lamp
finisher.
License lamp finisher
License plate
Rust found in this area
Figure 1
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/2
PARTS INFORMATION
MODEL
YEAR
2013-2015
Altima
2016 Altima
TRIM
LEVEL
DESCRIPTION
PART
NUMBER
QUANTITY
Base
License Lamp Finisher
Without Camera Without
Switch
84810-3TA2C
1
S
License Lamp Finisher
Without Camera With Switch
84810-9HM2A
1
S,SV,SL
License Lamp Finisher
With Camera With Switch
84810-9HM2B
1
Base
License Lamp Finisher
Without Camera
84810-9HS2A
1
S,SV,SL,
SR
License Lamp Finisher
With Camera
84810-9HS2C
1
CLAIMS INFORMATION
DESCRIPTION
Replace License Lamp Finisher
PFP
(1)
OP CODE
UM30AA
SYM
ZA
DIA
03
FRT
(2)
OR
DESCRIPTION
PFP
Replace License Lamp Finisher
Refinish Trunk Lid-Half Block Repair
OP CODE
SYM
DIA
UM30AA
(1)
Preparation & Mixing Time
ZL1GAA
ZZ99AA
FRT
(2)
ZA
03
(3)
(3)
(1) Reference the Parts Information Table and use the applicable Finisher as the PFP.
(2) Reference the current Nissan Warraty Flat Rate Manual and use the indicated FRT.
(3) Reference the current Nissan Warranty Paint Flat Rate Manual and use indicated FRT.
NOTE: Use expense code 019 for paint materials.
2/2
NTB16-119


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.