NTB17-022

Classification:
Reference:
EM17-001
Date:
NTB17-022
February 24, 2017
2014-2017 ROGUE; ENGINE AIR CLEANER CASE DUCT
SERVICE INFORMATION
APPLIED VEHICLE:
2014-2017 Rogue (T32)
NOTE: Does not apply to Rogue Hybrid.
SERVICE INFORMATION
When removing and installing the engine air cleaner case duct (case duct) in an APPLIED
VEHICLE for any reason, use the information in this bulletin in addition to the procedure in
the EM-Engine Mechanical section of the Electronic Service Manual (ESM).
Air cleaner
case duct
Air duct
assembly
(fore)
Figure 1
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/6
Case Duct Removal and Installation
1. Carefully unsnap both front tabs (see Figure 2).
Front
Tabs tabs
Figure 2
CAUTION: Do not pry outward on the upper portion of the front tabs at any time.
Do not pry outward
Do not pry outward
Front tabs
Figure 3
2/6
NTB17-022
2. Carefully unsnap the rear tab by pressing down (see Figure 4).
Rear tab
Figure 4
3. Carefully lift the case duct straight up (see Figure 5).
Case duct
Figure 5
3/6
NTB17-022
4. To reinstall the case duct.

Refer to this page and the next two pages.
Air cleaner
case (lower)
Tongue A
Tongue B
Figure 6
Top of case duct
Groove A
Groove B
Lip
Figure 7
4/6
NTB17-022
a. Line up the top of “tongue A” of the air cleaner case (lower) into “groove A” of the
case duct (see page 4, Figure 6 and 7, and Figure 8 below).
Groove A
Tongue A
Figure 8
b. Next, line up “tongue B” into “groove B” (see page 4, Figure 6 and 7, and Figure 9
below).

Use the lip to help line up both parts.
Groove B
Lip
Tongue B
Figure 9
5/6
NTB17-022
c. Carefully slide the case duct straight down while keeping both tongues and grooves
mated (see Figure 10).
Rear tab
Front tabs
Air duct
assembly
(fore)
Figure 10
d. Support the air duct assembly (fore) while carefully snapping the front tabs in place.
e. Snap in place the rear tab at the air cleaner case (see Figure 10).
6/6
NTB17-022