T-SB-0097-15

T-SB-0097-15
October 30, 2015
Short Pin Installation during PDS
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2016
Avalon, Avalon HV
ADDITIONAL INFORMATION
Introduction
To minimize battery discharge during transportation and storage, the Short Pin has been
removed at the assembly plant and temporarily stored in the engine compartment Relay Block.
Reinstall the Short Pin into its original location and confirm all related Diagnostic Trouble Codes
(DTCs) are cleared during Pre-Delivery Service (PDS).
NOTE
The Short Pin is removed only on vehicles going to Hawaii, Puerto Rico, Saipan, Guam, and
American Samoa.
Required Tools & Equipment
REQUIRED EQUIPMENT
Techstream 2.0*
Techstream Lite
SUPPLIER
PART NUMBER
QTY
TS2UNIT
ADE
1
TSLITEPDLR01
* Essential SST.
NOTE
Only ONE of the Techstream units listed above is required.
Software version 10.20.030 or later is required.
Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
© 2015 Toyota Motor Sales, USA
Page 1 of 3
T-SB-0097-15
October 30, 2015
Page 2 of 3
Short Pin Installation during PDS
Installation Procedure
Remove the Short Pin from the blank space of the Relay Block in the engine compartment and
install the Short Pin in the Relay Block as shown.
Figure 1
1
Relay Block
2
Remove this Short Pin
3
Install Short Pin Here
NOTE
The Short Pin does NOT function as a fuse, so install it only in the position shown.
If the vehicle is stored after PDS, disconnect the negative (–) battery terminal to prevent
battery discharge. Refer to Service Bulletin No. PG001-06, "Battery Maintenance for In-Stock
Vehicles and Pre-Delivery.”
DTC Clearing Procedure
With the Short Pin removed, several different ECUs may detect the interruption in battery voltage
(B+) and store a DTC. Clear any DTCs after installing the Short Pin.
1. Connect Techstream to DLC3.
2. Cycle the ignition switch to the “IG-ON” position.
© 2015 Toyota Motor Sales, USA
T-SB-0097-15
October 30, 2015
Page 3 of 3
Short Pin Installation during PDS
DTC Clearing Procedure (Continued)
3. Using Techstream, check to see if any DTCs other than those listed in the table below are stored.
DTC NUMBER
MEANING OF DTC
U0155
Lost Communication with “Combination Meter”
U0199 (with Memory Seat)
Lost Communication with “Door Control Module A”
U0200 (with Memory Seat)
Lost Communication with “Door Control Module B”
U0208 (with Memory Seat)
Lost Communication with “Seat Control Module A”
NOTE
If any DTCs besides those listed in the table remain, repair the applicable system according to
the Repair Manual.
4. Clear DTCs.
© 2015 Toyota Motor Sales, USA