ITB12-076b

Classification:
Reference:
Date:
BT12-022b
ITB12-076b
December 21, 2016
POWER BACK DOOR CALIBRATION
The Applied Vehicles in this bulletin have been amended. No other charges have been made.
Please discard previous versions of this bulletin.
APPLIED VEHICLE:
2013 JX (L50)
2014 – 2017 QX60 (L50)
2014 – 2017 QX60 Hybrid (L50)
SERVICE INFORMATION
The control motors for the power rear hatch (back door) are calibrated for smooth and even operation.
Adjustments or position change of the back door hinges or striker requires the back door to be re-calibrated.
The following are examples that can cause hinge position change requiring re-calibration:

Manually opening the back door aggressively, such that above normal force is exerted on the hinges as
the door stops at the full open position.

While opening the back door a wind gust pushes the door open, exerting above normal force on the
hinges as the door stops at the full open position.

With the back door open, the side of the door is heavily bumped.

Purposely performing adjustment to the door hinges or striker.
NOTE: If the back door reverses and closes while opening with an automatic/power open operation, it
is an indication that re-calibration is needed.
The Service Procedure in this bulletin provides the steps for back door re-calibration.
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe
that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.
1/5
SERVICE PROCEDURE
Back Door Re-Calibration
1. Make sure the rear hatch (back door) is fully closed and latched.

If needed, manually close the back door.
2. Connect the CONSULT-III (C-III) plus VI to the vehicle.
3. Turn the ignition ON and open C-III plus on the CONSULT PC.
4. Select Diagnosis (One System).
Step 4
Figure 1
2/5
ITB12-076b
5. Confirm the NISSAN/INFINITI tab is selected.
6. Click on the menu scroll arrow in the lower right corner.
Step 5
Step 6
Figure 2
7. Select AUTO BACK DOOR.
Step 7
Figure 3
3/5
ITB12-076b
8. Select Work support.
Step 8
Figure 4
9. Select RESET AUTO BACK DOOR STATUS.
10. Select Start.
Step 9
Step 10
Figure 5
4/5
ITB12-076b
11. Select Start.
12. Wait for “Current status” to change to COMPLETE.
13. Select End.
Step 11
Step 12:
Status will change to
COMPLETE
Step 13
Figure 6
14. Open the back door using an Automatic / Power Open Switch (i.e. key-fob remote, dash board switch).

Wait for the back door to fully open.
NOTE: The back door will open at half speed.

Two long beeps should be heard.

Calibration is complete.
15. Confirm all power back door operations function normally.

Hazard warning lamps blink and automatic back door warning buzzer sounds.
16. Disconnect the C-III plus VI from the vehicle.
17. Cycle the ignition: ON  OFF  ON, wait for at least 5 seconds,  OFF.
18. Fully close the back door.
5/5
ITB12-076b