ITB17-056

Classification:
Reference:
Date:
EL17-039
ITB17-056
November 27, 2017
2014 - 2018 Q70 AND QX80; INTELLIGENT KEY BATTERY DISCHARGED
APPLIED VEHICLES:
2014 - 2018 Q70 (Y51)
2014 - 2018 QX80 (Z62)
SERVICE INFORMATION
If the Intelligent Key is stored within 15 feet of the vehicle, the BCM may continue to “ping” the Intelligent Key
keeping it awake. Keeping the Intelligent Key awake may result in discharging its battery in a much shorter
period of time than normal (premature battery discharge).
Example: The Intelligent Key should not be stored in a lock box or other storage container attached to the
outside of the vehicle.
To prevent premature Intelligent Key battery discharge, store the Intelligent Key more than 15 feet from the
vehicle.
If unable to store the Intelligent Key more than 15 feet from the vehicle (for example, when a vehicle is on
display in the showroom); the following steps will prevent the BCM from continuing to “ping” the Intelligent Key:

Disable the welcome light function using the on-board methods outlined in this bulletin, or

Disable the welcome light function using the CONSULT-III plus methods outlined in this bulletin.
NOTE: If an Intelligent key is routinely stored within 15 feet of a vehicle while it is in dealer inventory, the
Intelligent Key battery should be replaced before the vehicle is delivered to the customer. This will ensure the
customer receives Intelligent Keys without premature discharge. Intelligent Key batteries replaced for this
reason are not covered under warranty.
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.
1/4
SERVICE PROCEDURE
On-board method to enable or disable the welcome light function
1. Turn the ignition switch to the ON position.
2. Open the driver side door.
3. Within 20 seconds after the ignition switch is turned to the ON position, push the driver side door handle
request switch for more than 5 seconds with the driver side door open.
4. A chime sounds when the setting is completed.
5. Turn the ignition switch to the OFF position.
6. Again, cycle the ignition to the ON, and then the OFF position.
7. Confirm that the welcome lighting function is turned ON or OFF by locking doors and approaching vehicle
with the Intelligent Key.
C-III plus method to enable of disable the welcome light function
1. Turn the ignition ON, engine OFF.
2. Connect the plus VI and start C-III plus.
3. Navigate to the C-III plus screen shown in Figure 1.

Diagnose (One System) or Diagnosis (All Systems) and then BCM.
4. Select INTELLIGENT KEY.
INTELLIGENT KEY
Figure 1
2/4
ITB17-056
5. Select WELCOME LIGHT OP SET.
WELCOME LIGHT OP SET
Figure 2
6. Select START.
Start
Figure 3
3/4
ITB17-056
7. Select CHANGE SET and verify the Current status changes from ON to OFF.
Current status will
change from On Off
CHANGE SET
Figure 4
8. Confirm the Current status is set to OFF.
9. Select END.
OFF
End
Figure 5
10. Confirm that the welcome lighting function is no longer active by locking doors and approaching vehicle
with Intelligent Key.
11. Make sure welcome light function is turned ON prior to customer delivery.
4/4
ITB17-056