L-TT-0200-16

Tech Tip L-TT-0200-16
April 26, 2016
Subject
Market
Hard Disk Drive (HDD) Replacement Procedure for
Gen 6 & 7 Navigation
USA
Service Category
Section
Audio/Visual/Telematics
Navigation/Multi Info Display
Applicability
Multiple Models
APPLICABLE VEHICLES
2010-2012
2010-2012
2012
2010-2012
2010-2012
2010-2011, 2013
2010-2013
2010-2011
HS250H
ES350
LFA
GX460
IS250
GS350
RX350
LX570
2010-2012
2010
2010-2012
2010-2013
2011-2012
2010-2012
2011-2012
IS250C
SC430
LS460
RX450H
CT200H
IS350
IS350C
CONDITION
When replacing the Hard Disk Drive (HDD) follow the instructions below:
RECOMMENDATIONS
1. Remove the Navigation Unit from the vehicle and replace the Hard Disk Drive (HDD) in the
Navigation Unit.
2. Install the Navigation Unit in the vehicle and press the ignition start button once without
stepping on the brake pedal (ACC ON). →Screen shows: “System Loading. Don’t turn off
the power.”
3. After loading completes, the map will be displayed on the screen.
Expires on
Ver. 2.7 01/01/2016 L
04/26/2017
© 2016, Lexus, a Division of Toyota Motor Sales, USA
Page 1 of 2
Tech Tip L-TT-0200-16
April 26, 2016
Subject
Market
Hard Disk Drive (HDD) Replacement Procedure for Gen
6 & 7 Navigation
USA
Applicability
Multiple Models
RECOMMENDATIONS
4. Press the ignition start button twice without stepping on the brake pedal (this will switch the
vehicle off) and WAIT FOR SIX MINUTES.
 Once the HDD is inserted into the Navigation Unit, the HDD has been paired with it.
 Once paired, it cannot be used with any other Navigation Unit
Figure 1.
(HDD Removal/Installation Instructions can be found on TIS)
Figure 2.
This message will appear when the HDD is not installed in the Navigation unit and the Navigation unit
will not function without the HDD.
LINK REFERENCES
This Tech Tip does not contain any link references
Expires on
Ver. 2.7 01/01/2016 L
04/26/2017
© 2016, Lexus, a Division of Toyota Motor Sales, USA
Page 2 of 2