LTB01306NAS1

LTB01306NAS1
TECHNICAL BULLETIN
01 AUG 2019
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional
Technicians with the knowledge, tools, and equipment required to do the job properly
and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should
not be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a
condition described affects your vehicle. Contact an authorized Land Rover service facility
to determine whether this bulletin applies to a specific vehicle.
INFORMATION
SECTION:
501-17
SUBJECT
/CONCERN:
Roof Opening Panel Seal Adrift
AFFECTED VEHICLE RANGE:
MODEL:
Discovery
(LR)
MODEL
YEAR:
2017-2019
MARKETS:
Canada, United States
VIN:
000225090175
ASSEMBLY
PLANT:
Solihull
APPLICABILITY:
Vehicles With: Roof Opening
Panel
CONDITION
SUMMARY:
SITUATION:
There is excessive wind noise from the roof opening panel.
CAUSE:
Roof opening panel seal retainment. Suggested customer concern code PD3.
ACTION:
Follow the instruction(s) below.
PARTS:
PART NUMBER
LR078295
DESCRIPTION
Glass adhesive kit
QUANTITY
1
WARRANTY:
NOTES:
Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Use TOPIx to
obtain the latest repair time.
The JLR claims submission system requires the use of causal part numbers.
Labor only claims must show the causal part number with a quantity of zero.
DESCRIPTION
Roof opening panel - Main seal - Apply
adhesive
Roof opening panel - Alignment
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
77.90.89.38
0.1
07
LR083242
76.84.82
0.1
07
LR083242
NOTE:
Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1.
Open the roof opening panel.
2.

Visually inspect the roof opening panel main seal.
If any part of the roof opening panel main seal is not installed
correctly, continue to step 3.
If the roof opening panel main seal is installed correctly, this is
not the cause of the customers concern. Continue diagnosis
using the TOPIx Workshop Manual section 501-17: Roof
Opening Panel - Diagnosis and Testing - Symptom Chart Wind noise.
3.

Clean the roof opening panel main seal and the surrounding area.
4.

Position the roof opening panel compression seal to one side.
5.

Position the incorrectly installed roof opening panel main seal to one side to gain
access to the seal channel.
6.

Apply the glass adhesive to the roof opening panel main seal channel.
7.
CAUTION:
Remove any excess glass adhesive from the seal/vehicle.
NOTE:
For better access, hold the roof opening panel air deflector in the closed
position.

Using a suitable tool, install the roof opening panel main seal.
8.
CAUTION:
Remove any excess glass adhesive from the seal/vehicle.

Install the roof opening panel compression seal.
9.
NOTE:
Allow the sealant to cure for 1 hour before washing the vehicle.
Close the roof opening panel.
10.
Align the roof opening panel (see TOPIx Workshop Manual section 501-17: Roof
Opening Panel - Roof Opening Panel Alignment).