NTB20-027

Service Bulletin Details

Public Details for: NTB20-027

Voluntary emissions recall campaign 2018 altima and rogue; exhaust manifold and three way catalyst assembly introduction nissan is conducting this voluntary emissions recall campaign on certain specific model year 2018 altima and rogu


- 2018 -

Classification:
Reference:
EM20-001
Date:
NTB20-027
March 31, 2020
VOLUNTARY EMISSIONS RECALL CAMPAIGN
2018 ALTIMA AND ROGUE; EXHAUST MANIFOLD AND
THREE WAY CATALYST ASSEMBLY
PC717
CAMPAIGN ID #:
APPLIED VEHICLES: 2018 Altima (L33)
2018 Rogue (T32)
QR25DE (4-cyl engine)
APPLIED ENGINE:
Check Service COMM or Dealer Business Systems (DBS)
National Service History to confirm campaign eligibility.
INTRODUCTION
Nissan is conducting this voluntary emissions recall campaign on certain specific model year
2018 Altima and Rogue vehicles. The exhaust manifold and three way catalyst assembly and
two exhaust sensors will be replaced. This service will be performed at no charge to the
customer for parts or labor.
IDENTIFICATION NUMBER
Nissan has assigned identification number PC717 to this campaign. This number must
appear on all communication and documentation of any nature dealing with this campaign.
DEALER RESPONSIBILITY
It is the dealer’s responsibility to check Service COMM or Dealer Business Systems (DBS)
National Service History for the campaign status on each vehicle falling within the range of
this voluntary emissions recall which for any reason enters the service department. This
includes vehicles purchased from private parties or presented by transient (tourist) owners
and vehicles in a dealer’s inventory. Federal law requires that new vehicles in dealer
inventory which are the subject of an emissions recall must be corrected prior to sale.
Failure to do so can result in civil penalties. While federal law applies only to new vehicles,
Nissan strongly encourages dealers to correct any used vehicles in their inventory before
they are retailed.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly
and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume
that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/9
IMPORTANT
Attention California Dealers
An Emission Recall Campaign Completion (ERCC) label must be filled out by the technician
performing the repair, and then attached to the underside of the vehicle hood. A sample of
the label is shown below.
Technician: Fill in here following:
“Replaced exhaust manifold and three-way
catalyst assembly, and two exhaust sensors
per campaign ID # PC717”
Fill in “DEALER CODE” and “DATE”
Put “ARB/EPA” under “CHANGE AUTHORITY”
NIS-UHL-16
Figure 1
California law prohibits owners from renewing their California registration if emissions related
recall work has not been performed. California dealers are now required to issue a proof of
correction certificate to vehicle owners upon completion of emissions related recall work.
Please fill out one of the campaign completion forms for each owner that has this campaign
performed. Instruct owners to keep this certificate unless they are requested to mail it to the
DMV. A sample of the form is shown in Figure 2 below.
Orange colored
Figure 2
NOTE:

These forms (item number CAEMRC 1-20) and labels (item number NIS-UHL-16)
are available from Nissan Publications (1-800-247-5321) at no charge.

When either item (form or label) is ordered, you will automatically receive the other
item as well.
2/9
NTB20-027
SERVICE PROCEDURE
IMPORTANT: Follow all cautions, warnings, and notes in the Electronic Service Manual
(ESM) when working on or around the engine.
1.
Replace the following:

Exhaust manifold and three-way catalyst assembly

Air fuel ratio (A/F) sensor 1

Heated (rear) oxygen sensor 2
 Altima: For exhaust manifold and three-way catalyst replacement, go to the
ESM, section ENGINE - ENGINE MECHANICAL - QR25DE - REMOVAL AND
INSTALLATION - EXHAUST MANIFOLD AND THREE WAY CATALYST.
 Rogue: For exhaust manifold and three-way catalyst replacement, go to the
ESM, section ENGINE - ENGINE MECHANICAL - REMOVAL AND
INSTALLATION - EXHAUST MANIFOLD AND THREE WAY CATALYST.
3/9
NTB20-027
Altima - Exhaust Manifold and Three Way Catalyst
7
4
Figure 3
1. Cylinder head
2. Exhaust manifold gasket
3. Exhaust manifold cover (upper)
4. Exhaust manifold and three
way catalyst assembly
5. Exhaust manifold cover (lower
front)
6. Exhaust manifold cover (lower
rear)
7. Air fuel ratio (A/F) sensor 1
4/9
NTB20-027
Altima - Exhaust System
1
Figure 4
1. Front exhaust tube hanger
2. Gasket
3. Front exhaust tube
4. Oxygen sensor
5. Oxygen sensor bracket
6. Ring gasket
5/9
NTB20-027
Rogue - Exhaust Manifold and Three Way Catalyst
7
4
Figure 5
1. Cylinder head
2. Exhaust manifold gasket
3. Exhaust manifold cover (upper)
4. Exhaust manifold and three
way catalyst assembly
5. Exhaust manifold cover (lower
front)
6. Exhaust manifold cover (lower
rear)
7. Air fuel ratio (A/F) sensor 1
6/9
NTB20-027
Rogue - Exhaust System
3
5
2
4
1
Figure 6
1. Ring gasket
2. Front exhaust tube
4. Heated oxygen sensor rear
5. Center exhaust tube
7/9
3. Exhaust gasket
NTB20-027
PARTS INFORMATION
Altima
DESCRIPTION
MANIFOLD ASSY - EXHAUST W / CATALYST
(California emissions equipped vehicles)
MANIFOLD ASSY - EXHAUST W / CATALYST
(non-California emissions equipped vehicles)
STUD
PART NUMBER
QUANTITY
140E2-9HS0A
1
140E2-3TA0A
1
14064-ZX60A
5
NUT
14094-9BA0A
5
GASKET - EXHAUST MANIFOLD
14036-3TA0B
1
STUD
14064-JG30B
3
NUT
01223-N0021
3
BOLT
14069-JD70A
11
GASKET - EXHAUST
20691-19U0A
1
GASKET - EXHAUST
20692-24U0A
1
AIR FUEL RATIO SENSOR
22693-3TY0B
1
HEATED OXYGEN SENSOR
226A0-3TA0B
1
DESCRIPTION
PART NUMBER
QUANTITY
MANIFOLD ASSY - EXHAUST W / CATALYST (1)
140E2-6FJ0A
1
STUD
14064-ZX60A
5
NUT
14094-9BA0A
5
GASKET - EXHAUST MANIFOLD
14036-3TA0B
1
STUD
14064-JG30B
3
NUT
01223-N0021
3
BOLT
14069-JD70A
11
GASKET - EXHAUST
20691-19U0A
1
GASKET - EXHAUST
20692-8H30A
1
AIR FUEL RATIO SENSOR (2)
22693-5RB0A
1
HEATED OXYGEN SENSOR
226A0-9BF0B
1
Rogue
(1)
(2)
For vehicles built from 09/2016 to 08/2018.
For vehicles built 09/2017 and later.
8/9
NTB20-027
CLAIMS INFORMATION
Submit a “CM” line claim using the following claims coding:
VEHICLE
CAMPAIGN (“CM”) ID
Altima
PC717
Rogue
DESCRIPTION
Replace Exhaust Manifold
And Three Way Catalyst,
A/F Sensor 1, And
Rear Oxygen Sensor
OP CODE
FRT
PC7170
1.4
PC7171
1.2
AMENDMENT HISTORY
PUBLISHED DATE REFERENCE
March 31, 2020
NTB20-027
DESCRIPTION
Original bulletin published
9/9
NTB20-027


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.