TIN-20-54-001REV
Service Bulletin Details
Public Details for: TIN-20-54-001REV
This technical information notice supersedes tin-20-54-001, issued may, 2020, to clarify when voltage measurements should be obtained.
- 2020 - 2019 - 2018 - 2017 - 2016 - 2015 - 2014 -
Models from 2017
2017 MITSUBISHI OUTLANDER |
Models from 2016
2016 MITSUBISHI OUTLANDER |
Models from 2015
2015 MITSUBISHI OUTLANDER |
Models from 2014
2014 MITSUBISHI OUTLANDER |
* * TECHNICAL INFORMATION NOTICE * * DATE: May 21, 2020 TO: Mitsubishi Motors US & Puerto Rico Dealer Service and Parts Managers RE: Voltage Measurement on Low Beam Halogen Headlight Bulbs and 12V Battery for 2014-2020 Outlander (RE) and 2018-2020 Outlander PHEV (R-EP) TIN NO. TIN-20-54-001REV This TIN supersedes TIN-20-54-001, issued May, 2020, to clarify when voltage measurements should be obtained. AFFECTED VEHICLES: 2014-2020 Outlander (RE) and 2018-2020 Outlander PHEV (R-EP) PURPOSE We are asking for your assistance with improving product quality. Your input is highly valued and appreciated. Voltage measurements are being requested on any Outlander and Outlander PHEV that presents with an inoperative headlight. Please see below for the specific request. For affected vehicles beyond the terms of warranty; please contact Mark Watts at (407) 572-4864, for further direction. Thank you for your attention to this matter. MEASUREMENT CONDITIONS Engine ON, Engine Speed 2000 rpm Headlight (low beam) ON Other lights and other accessories OFF MEASUREMENT POINTS 1. Measure and record the voltage at the positive battery terminal and negative battery terminal. Page 1 (4939) 2. Measure and record the voltage at the backside of the low beam halogen headlight bulb connectors (both sides). • Turn the low beam headlight connector cover counterclockwise to remove (see Photo 2). • Turn the low beam headlight connector counterclockwise to remove from the headlight assembly. • Replace any low beam headlight bulbs that are inoperative. • Place the voltmeter leads at the respective slots at the backside of the low beam headlight connector (see Photo 3 and Photo 4). • Turn ON the headlights to low beam. • Measure and record the voltage on both low beam headlight connectors. Photo 1 Page 2 (4939) Photo 2 Photo 3 Photo 4 – The bulb will generate heat. Secure the headlight bulb connector to a metal component with tape, and the headlight bulb away from plastic components. Do not touch the electrical leads or terminals due to possible electrical shock. Please include the voltage measurements in the REMEDY field of the Warranty claim in addition to the other repair details, with A1 for battery voltage and A2 for left headlight bulb voltage, and A3 for right headlight bulb voltage. Example below. Page 3 (4939) WARRANTY INFORMATION Please use Labor Operation Code 54101300 - 0.6 hours one bulb replacement, 0.9 hours two bulb replacement (both times include the 3 voltage checks). Page 4 (4939)