JTB00622NAS2

12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
JTB00622NAS2
TECHNICAL BULLETIN
16 DEC 2020
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional
Technicians with the knowledge, tools, and equipment required to do the job properly and
safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not
be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition
described affects your vehicle. Contact an authorized Jaguar service facility to determine
whether this bulletin applies to a specific vehicle.
INFORMATION
This reissue replaces all previous versions. Please destroy all previous versions.
This bulletin supersedes TSB JTB00622NAS1/2018 dated 24 MAY 2018, which should either
be destroyed or clearly marked to show it is no longer valid (e.g. with a line across the page).
Only refer to the electronic version of this Technical Bulletin in TOPIx.
Changes are highlighted in blue
SECTION:
309-00
SUBJECT/CONCERN:
Resonance/Vibration Into The Passenger Compartment At 1,500-2,200 Revolutions Per
Minute (RPM)
AFFECTED VEHICLE RANGE:
MODEL:
MODEL YEAR:
VIN:
ASSEMBLY PLANT:
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
APPLICABILITY:
1/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
MODEL:
MODEL YEAR:
VIN:
ASSEMBLY PLANT:
APPLICABILITY:
F-PACE (X761)
2017-2018
046303-049964
Solihull
INGENIUM I4 2.0L Diesel
F-PACE (X761)
2017
881324-899702
Solihull
INGENIUM I4 2.0L Diesel
F-PACE (X761)
2018-2020
240049-663002
Solihull
INGENIUM I4 2.0L Diesel
XF (X260)
2017-2020
Y11889-Y87654
Castle Bromwich
INGENIUM I4 2.0L Diesel
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
SITUATION:
A vibration can be felt through the vehicle body, seating and steering wheel when the
engine Revolutions Per Minute (RPM) are between 1500 RPM - 2200 RPM.
CAUSE:
Incorrect exhaust alignment.
ACTION:
Follow the instructions below.
WARRANTY:
NOTES:
Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Use TOPIx to obtain
the latest repair time.
The JLR claims submission system requires the use of causal part numbers. Labor
only claims must show the causal part number with a quantity of zero.
DESCRIPTION
Exhaust alignment
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
30.10.89.03
0.4
HZ
T4A11440
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
2/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
NOTE:
Normal Warranty procedures apply.
SERVICE INSTRUCTION:
NOTES:
Some variation in the illustrations may occur, but the essential information is always
correct.
This procedure contains illustrations showing certain components removed to
provide extra clarity.
All vehicles
1.
Open the hood.
2.

Loosen the right side engine mount nut.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
3/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
3.

Loosen the left side engine mount nut.
4.
Raise the vehicle on a ramp.
5.
WARNING:
Observe due care when working near a hot exhaust system.

Loosen the Diesel Particulate Filter (DPF) fasteners.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
4/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
All Wheel Drive (AWD) vehicles
6.

Loosen the transmission mount fasteners.
Rear Wheel Drive (RWD) vehices
7.

Loosen the transmission mount fasteners.
All vehicles
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
5/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
8.
WARNING:
Observe due care when working near a hot exhaust system.

Loosen the exhaust clamp.
9.
Lower the vehicle on the ramp.
10.
To align the exhaust, follow the steps below.
Start and stop the engine 4 times
Start the engine
Raise the engine RPM to between 3000 RPM and 4000 RPM - Repeat this
5 times
Stop the engine
Start and stop the engine 5 times.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
6/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
11.

Tighten the right side engine mount.
Torque: 60 Nm
12.

Tighten the left side engine mount.
Torque: 60 Nm
13.
Raise the vehicle on a ramp.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
7/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
AWD vehicles
14.

Tighten the transmission mount fasteners.
Torque: 60 Nm
RWD vehices
15.

Tighten the transmission mount fasteners.
Torque: 60 Nm
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
8/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
All vehicles
16.
WARNING:
Observe due care when working near a hot exhaust system.

Tighten the DPF fasteners.
Torque: 25 Nm
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
9/10
12/16/2020
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
17.
WARNING:
Observe due care when working near a hot exhaust system.

Tighten the exhaust clamp.
Torque: 55 Nm
18.
Lower the vehicle on the ramp.
19.
Close the hood.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1608124060736
10/10