TIN-20-13-001REV

Service Bulletin Details

Public Details for: TIN-20-13-001REV

This technical information notice was sent to dealers providing instructions for reprogramming the engine control module pertaining to dtc P0010 - P0017.


- 2022 - 2021 - 2020 - 2019 - 2018 -

* * TECHNICAL INFORMATION NOTICE * *
DATE:
July 30, 2021
TO:
Mitsubishi Motors US Service and Parts Managers
RE:
DTC: P0010-P00017 Troubleshooting - Revision
TIN NO.
TIN-20-13-001REV

This TIN supersedes TIN-20-13-001, issued October 2020, to inform the investigation has
concluded for the Valve Timing System, Camshaft and Crankshaft DTCs. The new/
revised information is italicized and indicated by .
AFFECTED VEHICLES: 2018-2022 Eclipse Cross
PURPOSE
MMNA would like to remind all dealers and technicians that FFD DATA, and ALL-DTC Data is
required for warranty approval for all P0010 – P0017 codes. *
Please review the flowchart on the following page.
*When faced with a P0010 through P0017 code that is an intermittent concern, attempt to obtain
a drive recording. Start by interviewing the customer on the way the vehicle was being driven at
the time the Check Engine light illuminated. Review the FFD and attempt to duplicate the same
conditions during the driving pattern. Once established, create a Techline case and then
perform a data recording that includes the below items and be sure to upload all Data
Recordings, FFD, and ALL-DTC data to the Techline case. Warranty submission must also include
all measurements taken and details on the diagnostic steps taken and results for each step.
MMNA has concluded an investigation into DTCs pertaining to the Valve Timing System, Camshaft
and Crankshaft phase position. DTC P0011 and P0014 codes may be stored and the check
engine light may illuminate in the absence of the drivability concern or mechanical fault. It is
recommended that Technical Service Bulletins pertaining to DTC P0011 and P0014 be followed
for further instruction and Engine Control Module reprogramming procedures. For other DTCs
relating to Camshaft and Crankshaft Phase or the Engine Oil Control Valve Circuits, follow the
diagnostic procedures outlined in the Service Manual.
Page 1 of 2
(5105)
Page 2 of 2
(5105)


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.