01130820335612

Technical Service Bulletin
01 MIL on (DTC P0300, P130A, and/or P0301 through P0304)
01 13 08 2033561/2 June 21, 2013. Supersedes Technical Service Bulletin Group 01 number 13-95 dated May 13,
2013 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
A3
2010 - 2011
000001 - 999999
CBFA and CCTA Engine code
TT
2010 - 2011
000001 - 999999
CBFA and CCTA Engine code
A4/A4 Avant
2010
A4/A4 Avant
2011
A5 Cabriolet
2010
016353 - 999999
CAEB Engine code
A5 Cabriolet
2011
000001 - 044955
CAEB Engine code
A5
2010
0049118 - 999999
CAEB Engine code
A5
2011
000001 - 062612
CAEB Engine code
Q5
2011
000001 - 084488
CAEB Engine code
AA121937 - AA999999
AN045790 - AN999999
BA000001 - BA128744
BN000001 - BN045180
CAEB Engine code
CAEB Engine code
Condition
REVISION HISTORY
Revision
Date
Purpose
2
-
Revised Warranty (Corrected error in labor operation code for test drive)
1
5/13/13
Initial publication
• One or more of the following faults is stored in the engine control module (ECM) (address word 01):
• DTC P0300 (Random/Multiple Cylinder Misfire Detected)
• DTC P0301 – DTC P0304 (Cylinder 1 – Cylinder 4 Misfire Detected)
• DTC P130A (Hide Cylinder)
• Engine shakes.
Technical Background
Some of the Bosch ignition coils installed in the affected vehicles may fail prematurely.
© 2013 Audi of America, Inc.
Page 1 of 5
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.
Technical Service Bulletin
Production Solution
Not applicable.
Service
1. Confirm that misfire faults are stored in the ECM memory.
2. Disconnect the connectors from the ignition coils by first
pushing the connector towards the ignition coil, then pulling
the release tab with thumb, then pulling the connector off
the ignition coil (Figure 1).
Figure 1. Correct method of disconnecting the
ignition coil.
Note: Never use a screw driver, pick or any other tool
to unlock and remove the connector, as damage to the
connector may occur (Figures 2 and 3).
Figure 2. Incorrect method of disconnecting the
ignition coil.
© 2013 Audi of America, Inc.
Page 2 of 5
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.
Technical Service Bulletin
Figure 3. Incorrect method of disconnecting the
ignition coil.
3. Check the part number of the coils (Figure 3). If one of the
following part numbers is installed, all four ignition coils will
need to be replaced:
• 06H 905 115
• 06H 905 115 A
• 06H 905 115 B
Figure 3. A) part number, B) Bosch symbol.
4. Replace all four ignition coils with part number 07K905715F (ELDOR).
Note: Always use special tool T40039 to remove
ignition coils (Figure 4).
Figure 4. Special tool T40039.
© 2013 Audi of America, Inc.
Page 3 of 5
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.
Technical Service Bulletin
5. Erase the DTC memory from the ECM.
6. Test drive the vehicle to verify that the misfire is no longer present.
7. If the misfire is still present, perform further diagnosis via Guided Fault Finding.
Warranty
This repair only applies to vehicles specified in this TSB. This repair does not apply to any other vehicles and
claims for this repair on non-eligible vehicles will not be reimbursed under warranty.
Claim Type:
Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin
is informational only.
Service Number:
2820
Damage Code:
0040
Labor Operations:
Replace all four ignition coils (All vehicles except A3 and
TT)
2820 2013
40 TU
2820 2017
40 TU
GFF - Checking and clearing fault codes included in
existing labor operations
0150 0000
20 TU
Road test prior to service procedure
No allowance
0 TU
Road test after service procedure
0121 0004
10 TU
Replace all four ignition coils (A3 and TT vehicles only)
Diagnostic Time:
Technical diagnosis at dealer’s discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:
As per TSB #2033561/2
Required Parts and Tools
Part Number
Part Description
Quantity
07K905715F
ELDOR Ignition Coil
4
Tool number
Tool Description
Quantity
N/A
VAS Tester
1
T40039
Ignition Coil removal Tool
1
© 2013 Audi of America, Inc.
Page 4 of 5
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.
Technical Service Bulletin
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with
your Parts Department and service manuals for the latest information.
© 2013 Audi of America, Inc.
Page 5 of 5
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.