NTB22-099A

Classification:
Reference:
AT22-015A
Date:
NTB22-099A
December 20, 2022
VIBRATION DURING LIGHT OR MODERATE THROTTLE INPUT
This bulletin has been amended. See AMENDMENT HISTORY on the last page.
Please discard previous versions of this bulletin.
APPLIED VEHICLES:
2017-2019 Armada (Y62)
2017-2021 NV1500/2500/3500 (F80)
2017-2019 Titan/Titan XD (A61)
APPLIED DATES:
Armada: Built on or before July 22, 2018
Titan/Titan XD: Built on or before September 12, 2018
APPLIED TRANSMISSIONS: 7 Speed Automatic
IF YOU CONFIRM
A vibration during light or moderate throttle input between 20 – 40 mph,
OR
RPM flare / slip feeling / vibration during or immediately after a 2 – 3 upshift or 3 – 4 upshift
with light or moderate throttle input.
ACTION
Replace the Torque Converter.
IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you
will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it
contains information that is essential to successfully completing this repair.
Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3
SERVICE PROCEDURE
1.
Remove the transmission assembly from the vehicle.

Refer to the ESM: TRANSMISSION & DRIVELINE > TRANSAXLE &
TRANSMISSION > 7AT: RE7R01B > UNIT REMOVAL AND INSTALLATION >
TRANSMISSION ASSEMBLY > Removal and Installation
2.
Remove the Torque Converter from the transmission assembly.
3.
Install a new Torque Converter from PARTS INFORMATION.
IMPORTANT:
o Be sure to install a new input shaft O-ring when replacing the Torque
Converter.
o After installing the Torque Converter into the transmission assembly, check
dimension (A) before installing the transmission assembly in the vehicle.
 (A): Dimension between the end of the converter housing and the Torque
Converter 24.0 mm (0.94 in.).
Figure 1
4.
Reinstall the transmission assembly into the vehicle.

Refer to the ESM: TRANSMISSION & DRIVELINE > TRANSAXLE &
TRANSMISSION > 7AT: RE7R01B > UNIT REMOVAL AND INSTALLATION >
TRANSMISSION ASSEMBLY > Removal and Installation
2/3
NTB22-099A
PARTS INFORMATION
DESCRIPTION
PART NUMBER
QUANTITY
TORQUE CONVERTER
SEAL – O RING
(Input Shaft O-Ring)
31100-1XR2E
1
31526-90X05
1
NOTE: Refer to the Library in the EPC for the Single Use Parts List.
CLAIMS INFORMATION
Submit a Primary Part (PP) type line claim using the following claims coding:
DESCRIPTION
PFP
R&I Automatic Transmission Assembly
Replace Torque Converter
(1)
(2)
(1)
OP CODE
JA01AA
JA041A
SYM
DIA
FRT
ZE
32
(2)
Reference the electronic parts catalog and use the Torque Convertor (31100-*****) as
the Primary Failed Part (PFP).
Reference the current Nissan Warranty Flat Rate Manual and use the indicated Flat
Rate Time (FRT).
AMENDMENT HISTORY
PUBLISHED DATE REFERENCE
November 15, 2022
NTB22-099
December 20, 2022
NTB22-099A
DESCRIPTION
Original bulletin published
APPLIED VEHICLES revised
3/3
NTB22-099A