C0022
Brake Booster Solenoid (Subfault)
DTC C0022, sometimes indicated as C002200 is an OBD diagnostic trouble code indicating a generic fault with the vehicle chassis.
- C0022: Brake Booster Solenoid (Subfault)
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- TJ31473.5.0-2016 - BRAKES (PWS)
VOLVO: This is a technical journal: if there is an unusual noise from abs system together diagnostic trouble code bcm-C002201, then follow advice in service. It may be necessary to replace booster or connectors production has changed the routing o - TJ31473302016090 - BRAKES (PWS)
VOLVO: This is a technical journal: if there is an unusual noise from abs system together diagnostic trouble code bcm-C002201, then follow advice in service. It may be necessary to replace booster or connectors production has changed the routing o
2012 FORD FUSION HYBRID with 27975.0 miles
Temperature was -3 deg f. Started car from being cold overnight. Let engine run no more than 3 minutes prior to backing out of drive way. Made two successful stops. Drove 3/8 mile from last stop while traveling at 30 mph. Slowed to make right turn on desired street because traffic light was green. While turning brake warning light illuminated. Abs failure and traction control failure lights illuminated. Vehicle was very hard to stop with foot brake. Loss of all power assistance for stopping. Dealer recorded abs system test, C0022, abs pinpoint test p, circuit test, excessive resistance between pins 17 and 31. At abs module connector c135, 3.3 ohms, trace, removed and installed pcm and master cylinder to access and repair wire circuits cca22 grey with yellow and vca22 green with brown, green corrosion at connector C1602 pins 3 and 4 near the brake booster solenoid connector.
SERVICE BRAKES,
2012 FORD FUSION HYBRID with 28268.0 miles
This is 2nd of 3 complaints because the car was taken to the dealer three times for three incidents with same symptoms. Temperature was -3 deg f exactly as was on the previous complaint. Started car from being cold overnight. Let engine run no more than 3 minutes prior to backing out of drive way. After two successful stops and while accelerating to around 15 - 20 mph, brake warning light illuminated. Abs failure, stability control and traction control failure lights illuminated (left off stability control warning from previous report). Vehicle was very hard to stop with foot brake. But was easier to stop since repair from previous week on 2/16/15. Dealer recorded abs system test, C0022, abs pinpoint test p, circuit test brake booster solenoid, intermittent brake booster solenoid operation per ppt p6, replaced the brake booster assembly per ppt p7.
SERVICE BRAKES, ELECTRONIC STABILITY CONTROL
2011 FORD FUSION with 63988.0 miles
At least three times on separate occasions, abs warning lights came on and engaged suddenly while there was a loss of braking power. Brakes were spongy and could barely stop the car. Trouble codes C00002 C0022, C1012, U0415 and U30000 codes showed. My mechanics checked my mechanical brake systems and all were fine and found no problem. My mechanic thinks a computer problem is the issue. I took car to local Ford dealer and they found no braking problem.
SERVICE BRAKES,