Bmw 128i-coupe 2013

• Recall 230170 [USA]: An electrical short can cause the pcv valve heater to overheat, increasing the risk of a fire while driving or, soon after driving when parked.
  Bmw of north america, llc (bmw) is recalling certain 2008-2013 1 series coupe (128i); 2007-2013 3 series coupe (328i, 328xi, 328i xdrive); 2007-2010 x3 sav (x3 3.0si, x3 xdrive30i); 2008-2013 1 series convertible (128i); 2006-2011 3 series sedan (325i, 325xi, 328i, 328xi, 328i xdrive, 330i, 330xi); 2006-2012 3 series wagon (328i, 328i xdrive); 2007-2013 3 series convertible (328i); 2006-2010 5 series sedan (525i, 525xi, 528i, 528xi, 530i, 530xi); 2006-2007 5 series wagon (530xi); 2007-2010 x5 sav (x5 3.0si, x5 xdrive30i); 2006-2008 z4 coupe (z4 3.0si); and 2006-2011 z4 roadster (z4 3.0i, z4 3.0si, z4 sdrive30i) vehicles. The heater for the positive crankcase ventilation (pcv) valve may short circuit.
  this recall supersedes and expands previous nhtsa recalls 17v-683 and 19v-273. Dealers will install an electrical wiring harness with fuse protection for the pcv valve heater in potentially affected vehicles, free of charge. This recall supersedes and expands previous nhtsa recalls 17v-683 and 19v-273. Vehicles previously repaired under the prior recalls will need to come back for the new recall remedy. The remedy is currently being developed. Interim owner notification letters informing owners of the safety risk were mailed on april 1, 2022. Owner notification letters were mailed on july 22, 2022. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Nhtsa.Gov.

  Show Content

• Recall 179337 [USA]: An inflator explosion may result in sharp metal fragments striking the driver or other occupants resulting in serious injury or death.
  Bmw of north america, llc (bmw) is recalling certain 2008-2013 128i and 135i convertibles, 128i, 135i, and m coupes, 2007-2010 x3 30si and x3 xdrive30i, 2013-2015 x1 sdrive28i, x1 xdrive28i and x1 xdrive35i, 2007-2013 328i, 328i xdrive, 335i, 335is, 335i xdrive and m3 coupes, 2006-2011 328i, 328xi, 328i xdrive, 325i, 325xi, 330i, 330xi, 335i, 335xi, 335i xdrive and m3, 2009-2011 335d, 2006-2012 325xi, 328i, 328xi and 328i xdrive, 2010-2011 x6 activehybrid, 2007-2013 328i, 335i, 335is, m3 coupes, x5 30si, x5 xdrive30i, x5 xdrive35i, x5 48i, x5 xdrive48i, x5 xdrive50i and x5 m, 2009-2013 x5 xdrive35d and 2008-2014 x6 xdrive35i, x6 xdrive50i and x6m vehicles equipped with non-desiccated driver frontal air bag inflators containing phase stabilized ammonium nitrate (psan) that were used as interim remedy parts for previous takata recalls. These inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.
  bmw will notify owners, and dealers will replace the driver air bag. On x5 and x6 vehicles, only the inflator will be replaced. All repairs will be performed free of charge. The recall began march 11, 2020. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 107813 [USA]: In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death.
  Bmw of north america, llc (bmw) is recalling certain model year 2008-2013 128i and 135i coupes and convertibles and 1 series m coupes, 2006-2011 325i, 325xi, 328i, 328xi, 328i xdrive, 330i, 330xi, 335i, 335xi, 335i xdrive sedans, 2009-2011 335d sedans, 2006-2012 325xit, 328i and 328xi sports wagons, 2007-2013 328i, 328xi, 328i xdrive, 335i, 335xi, 335i xdrive, 335is and m3 coupes and convertibles, 2013-2015 x1 sdrive28i, x1 xdrive28i and x1 xdrive35i savs, 2007-2010 x3 xdrive30i savs, 2007-2013 x5 xdrive30i, x5 xdrive35i, x5 xdrive48i, x5 xdrive50i and x5 m savs, 2009-2013 bmw x5 xdrive35d savs, 2008-2014 x6 xdrive35i, x6 xdrive50i, and x6 m sacs, 2010-2011 bmw x6 xdrive50i sacs and 2008-2011 m3 sedan vehicles. Upon deployment of the driver's frontal air bag, excessive internal pressure may cause the inflator to rupture.
  bmw will notify owners, and dealers will replace the driver's frontal air bag module or inflator depending on the vehicle model, free of charge. The recall began march 9, 2018. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Desiccated air bag inflator rupture investigation # EA21002

  From 2000 through 2017, takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("psan") propellant -- propellant 2004 and propellant 2004l. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 blomquist report at www.Nhtsa.Gov/sites/nhtsa.Gov/files/documents/expert_report-hrblomquist.Pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in us vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004l that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated psan inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All takata inflators produced with propellant 2004l contain desiccant, and none of these desiccated inflators using propellant 2004l are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated psan inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- takata (now known as tk global), the independent testing coalition, and exponent -- have been studying the long-term behavior of takata desiccated psan inflators using propellant 2004l (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004l is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004l.The office of defects investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated psan frontal inflators manufactured by takata. This investigation will require extensive information on takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated psan inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.Gov/recalls?Nhtsaid=ea21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede ea15-001, which remains open.
  

  Show Content

Driver's side door lock/latch (actuator) occasionally will not unlock using normal physical force, only unlocks with electrical assistance from unlock button on dashboard or key fob. Could be dangerous in an accident where battery power is cut off (by design) - the occupant is unable to egress and remains trapped inside vehicle. Others have experienced similar problems with these lock actuators on other doors and on other models (per forum discussions). Bmw will not cover cost of repair if outside of warranty. Bmw part number 51217202143 (system latch)

"takata recall" i have called two dealerships to have my airbag replace and my airbag light is also on and they say the part would have to be ordered and it would be 2 weeks (united bmw gwinnett) and i asked to speak to the manager and i left a message and it has been a week with no response. This a dangerous car at this point to drive but bmw does not seem to be taking serious ly. I then called nalley bmw and the said it would take two weeks to get the part in. I am scared for my life if this airbag deploys and my grandchildren are in the car. How can we expidite this service to get my car fixed or do they want to pay for me to get a rental, or do they want to take the risk of the airbag hurting me or my grandchildren?

Takata recall i own a bmw series 1 128i year 2013. I received a notice on september 2017 stating that there is a defect on my air bag , and to make an appointment at the nearest bmw. I have called bmw of fort lauderdale and bmw of pembroke pines unsuccessfully, since i am told they don't have the replacement and need to order. They never have called me back. I also called customer relations and i was told the whole country is working on the recalls and the airbags are not available.I am concerned for my safety. I was also told nothing could happen to me in an event of an accident...So why the urgency and nobody is helping remedy this important safety recall [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(b)(6). *tr

Tl* takata recall. The contact owns a 2013 bmw 128i .The contact received notification of nhtsa campaign number: 16v071000 (air bags) however, the parts to do the repair were unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The dealer fields bmw south orlando located at 9750 s orange blossom trail, orlando, fl 32837 and fields bmw winter park dealer located at 963 wymore rd, winter park, fl 32789 were contacted and confirmed that the parts were not available for the recall remedy. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

Cpsc:working with my mechanic, it was discovered over the course of 2 months, that the front seatbelts and several of the airbags had either been disabled or removed. *dt *js*dt*jb

Even though a recall is on the car, my bmw dealership will not fix this.

Nothing -- yet. But bmw refuses to replace my airbags, as required by law.

Tl* takata recall. The contact owns a 2013 bmw 128i. The contact received notification of nhtsa campaign number: 16v071000 (air bags); however, the part needed for the repair was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The contact called reeves bmw tampa (109 e fowler ave, tampa, fl 33612, phone number: (813) 936-5500) and was informed that the part for the repair was not available. The manufacturer stated that they did not have a date for when the part would become available. The contact had not experienced a failure. Parts distribution disconnect.

Bmw is stalling unnecessarily and will not fix my recalled airbag(s).