Bmw F650 Gs 2006
Vehicle Details: Recalls, Consumer Complaints, Service Bulletins
Use the box here to look up VINs from BMW as well as other manufacturers
Sub-models: - F650 Gs Dakar -
-
Where is the 2006 BMW F650 Gs produced?
- The 2006 BMW F650 Gs is produced in Munich Bavaria, Germany.
-
Are there recalls for the 2006 BMW F650 Gs?
- There are 3 recall(s) for the 2006 BMW F650 Gs, additional information is below.
Recall 32069 [USA]: If this occurred when the motorcycle was parked, the motorcycle could fall to the ground and injure a person sitting on the motorcycle or a person nearby.
Recall RM/2010/023 [UK]: Braking performance may be affected
Recall 2007115 [Canada]: Other
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- B611305 - ELECTRICAL SYSTEM: The electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on ho
- MC610321 - ELECTRICAL SYSTEM:12V/24V/48V BATTERY: The motorcycle will not start. The vehicle battery is empty even though the battery charger was permanently connected to the 12v power socket.
- MC460521 - STRUCTURE: Stress corrosion cracks may occur on the studs of certain milled footrests from the bmw motorrad special accessories catalog for the gs models.
- MC310102 - STRUCTURE: We have been notified by showa, the manufacturer of the front forks for the f 650 dakar model, that one of the four mounting bolts, attaching the fork stabilizer to the fork legs is incorrect
- MC55297495 - ELECTRICAL SYSTEM: Vehicle battery not charged despite the battery charger being connected to the on-board socket (manufactured before 2009)headlights and rear lights light up intermittently despite the ignition being switched off and the battery charger bein
- MC610208 - ELECTRICAL SYSTEM: The wiring harness of the f 650 gs and f 650 gs dakar (r13) models is routed along the right-hand top rail of the frame. Weld spatter on the frame and/or adverse routing in the vicinity of the banjo bolt of the hydraulic spring base adjuste
- MC210221 - POWER TRAIN: The clutch plates do not tolerate frequent and prolonged operation at the clutch friction zone, causing a shorter service life in motorcycles that see intensive use
- MC51142327 - EQUIPMENT: Leaks have been reported in fork legs. The cause is reported be from oil lubricating film with accompanying dirt/grease ring is incorrectly interpreted to be a leaking fork leg. Investigations have shown that the part is not defective.
- B611305 - EQUIPMENT ADAPTIVE/MOBILITY: Discharged battery energy diagnosis must be performed: the electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This doc
- SIB-63-02-01 - EXTERIOR LIGHTING: Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
- SIB-16-02-09 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP: Bmw vehicles: fuel level sensor repairs. Where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel
- SB-00-021-07 - FUEL SYSTEM, OTHER: Bmw motorcycle: engine fuels containing ethanol. Bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. Ethanol mixtures in proportions higher than 10%
- TSB-17-001-09 - ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS: Bmw motorcycle: the coolant inlet hose is not compliant with the applicable bmw specifications. Engine operation can cause the inlet hose to widen and become correspondingly shorter; overtime this contraction in length can cause the hose to
- TB-61-002-08 - ELECTRICAL SYSTEM:WIRING: Bmw mc: wiring harness of motorcycles is routed along right hand top rail of frame. Weld spatter on frame and/or adverse routing in vicinity of banjo bolt of hydraulic spring base adjuster can result in chafing of the wiring harness. M
- SB-61-003-08 - VEHICLE SPEED CONTROL:CABLES: Bmw vehicles: routing abs front wheel speed sensor cable. The wiring harness front wheel speed sensor periphery plug connection is mounted on the fork cover at the bottom. *pe
- 13-003-08 - STEERING: STEERING WHEEL/HANDLE BAR: Bmw motorcycle: replacement of fuel-pressure sensor. Check of position of protective film (f-800 gs only). *pe
| Crash | Fire | Towed | Injured | Deaths | Failure Date |
|---|
| No | Fire | N | None | None | 20200507 |
Tl* the contact owns a 2006 bmw f 650. The contact stated that oil was leaking from the oil tank down unto the exhaust causing the vehicle to smoke. The contact was concerned that a fire may start. The vehicle was not taken to a dealer for a diagnostic testing. The manufacturer was not made aware of the failure. The failure mileage was approximately 7,000. *ln consumer stated while driving the oil would drip on the engine and exhaust.*jb
| No | Fire | N | None | None | 20200506 |
Tl* the contact owns a 2006 bmw f 650. The contact stated that oil was leaking from the oil tank down unto the exhaust causing the vehicle to smoke. The contact was concerned that a fire may start. The vehicle was not taken to a dealer for a diagnostic testing. The manufacturer was not made aware of the failure. The failure mileage was approximately 7,000. *ln consumer stated while driving the oil would drip on the engine and exhaust.*jb
| No | Fire | N | None | None | 20080208 |
Motorcycle had 12,000 + miles on it when an electrical fault caused part of the wiring harness to burn. Fortunately i was attempting to start the motorcycle when this happened, not driving down the road. *tr