2013 BMW F800 GtBmw F800 Gt 2013

Vehicle Details: Recalls, Consumer Complaints, Service Bulletins

Below you will find all available information on the 2013 BMW F800 Gt, manufacturered by Bmw Ag Motorcycles.

ManufacturerKnown WMI(s)Fuel Type
BMWWB3 WB4
BMW VIN Decoder

Use the box here to look up VINs from BMW as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 2013 BMW F800 Gt produced?
     - The 2013 BMW F800 Gt is produced in Munich Bavaria, Germany.
  • Are there recalls for the 2013 BMW F800 Gt?
     - There are 6 recall(s) for the 2013 BMW F800 Gt, additional information is below.
NHTSA Mandated Recalls
  • Recall 130627 [USA]: If other drivers cannot easily see the turn signals, there would be an increased risk of a crash.

  • Recall 130353 [USA]: If the rear reflex reflectors are obscured from view, it can increase the risk of a crash.

  • Recall 101942 [USA]: An unexpected shutdown increases the risk of a crash.

  • Recall RM/2014/007 [UK]: Engine may stall

  • Recall 2017428 [Canada]: Lights and instruments

  • Recall 2014045 [Canada]: Electrical

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • B611305 - ELECTRICAL SYSTEM: The electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on ho
  • SIM010917 - EQUIPMENT: Shipping specific non-deployed vehicle safety devices to lighting resources, llc. This service information bulletin provides information on shipping "specific" noin-deployed vehicle safety devices that are classified as dangerous goods (dg)
  • SIM010717 - ENGINE AND ENGINE COOLING: The engine?S intake charge-air duct limited warranty extension to 10 years/120,000 miles applies to ?Eligible usspecification
  • SIM010617 - BRAKES (PWS): Visual inspection of brake discs/rotors for new car deliveries
  • MC000521 - ELECTRICAL SYSTEM: One of the following situations can occur when connecting to bn2000 motorcycles: 1. The installed control units cannot be found when reading out with ista. 2. Control units initially communicate after connecting to the vehicle, but communic
  • MC210221 - POWER TRAIN: The clutch plates do not tolerate frequent and prolonged operation at the clutch friction zone, causing a shorter service life in motorcycles that see intensive use
  • B510415 - VISIBILITY: The customer complains of rattling noises from the rear window when driving on rough roads.
  • B170318 - ELECTRICAL SYSTEM: Butt connector for repairing a plug connection. The ?Top up coolant? Message is displayed in the central display (cc message id 166). When checking the cooling system there are no leaks found and the expansion tank is filled to the proper l
  • MC35742107 - ENGINE AND ENGINE COOLING: Loss of coolant from expansion tank. Coolant escapesfrom the expansion tank. Construction design of the expansion tank and breather cap.
  • MC1100116 - FUEL SYSTEM, GASOLINE: Coolant pump drain hose. Details the coolant pump is fitted with a radial shaft seal on the oil-side and on the coolant-side is a mechanical seal. Mechanical seals are reliable an durable, yet for technical reasons, they always exhibit min
  • MC56005564 - EQUIPMENT: Heated handlebar grips intermittently not working
  • MC55813536 - EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM): Navigator v maintains a bluetooth connection to a mobile phone for a short period.
  • MC63308496 - POWER TRAIN:DRIVELINE: Frequent failure of the gear indicator and engine running issues after changing the final drive ratio (drive chain and sprockets) on k7x bikes with electronic throttle control.
  • MC2300117 - POWER TRAIN:MANUAL TRANSMISSION:COLUMN SHIFT ASSEMBLY: Customer complains about an operating failure on the left or right multifunction switch.
  • MC59759165 - ENGINE (PWS): Transmission rattles when the engine is at operating temperature and idling.
  • MC61461571 - EXTERIOR LIGHTING:HEADLIGHTS: Mist forms in the headlight. This is due to condensation and goes away again.
  • MC64010520 - ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL: Incorrect tire pressure appears in the instrument cluster. Contamination or obstruction of the rdc sensor.
Most Recent Consumer Complaints and Accidents
CrashFireTowedInjuredDeathsFailure
Date
NoNoN NoneNone20191107

08/30/2013, 1st owner replaced fuel level sensor, 3365 miles. 01/05/2018 bike shows reserve fuel light, 4 miles later stalls, middle of #2 lane at i-15/hwy 60 transition in socal. Heavy traffic. Semi trucks covered me pushing dead bike to safety lane. Rolled to/refueled bike at nearest gas station, took <1 gallon, has 4 gallon tank. Bike starts ok, thought i accidentally stalled it. 06/16/2018, 2000 mile ride, bike lost power. E/b i-15 in az, virgin river gorge. Bike dies in passing lane. Attempt restarts, wild idle, bike still dies. Pull into emergency parking. No alternate access, no cell coverage. Starts/dies entire way to st. George ut, salina ut. Bike starts ok after fueling. Spoke w/service on phone, no local dealers. 06/20/2018, denver bmw diagnoses failing fuel pump, we replace ($800). 06/06/2019 bike stalls/dies, off i-5 gorman, gassing up. 06/15/2019, bike has wild idle, stalls/dies, palomar road. Return to dealer, service says pump is ok. 07/11/2019, replace fuel pump controller ($200). 07/13/2019 bike stalls/dies in traffic, on hwy 14 in palmdale, middle of offramp intersection. Stalls/dies return ride. 08/20/2019 bike stalls/dies on hwy 138 in traffic, w/b and e/b from palmdale. 08/31/2019 bike stalls/dies on hwy 38 in traffic, w/b. Return to service directly to run codes. Repeatedly stalls/dies on hwy 38, i-10, i-215, 91 fwy, on way to dealer. Freeway traffic at speed and congestion. Push bike through intersections, bike refuses to idle. Dealer tests all electrical, recommends new ecu ($1000). 11/07/2019 bike ready for pickup. 11/08/2019 pick bike up, stalls/dies in middle of city intersection in heavy traffic, 6 miles/20 minutes from dealer. Truck sent to pick it up. Dealer now replaces the fuel pump. Bike is unsafe to ride, continuous fuel failure, web search shows this is a well-known failure with f800 bikes, bmw na appears indifferent.

NoNoN NoneNone20170930

2013 bmw . Consumer writes in regards to safety recall -481. *lad the consumer was advised the motorcycle was not included in the recall or that the recall did not exist. The consumer was seeking clarification. Updated 11/22/2017*js

NoNoN 1 InjuredNone20150502

Today, 5/2/2015, it was about 90 degrees ambient in los angeles and ellen and i went on a breakfast ride into the mountains. Today, i took a non-contact ir laser temperature gun infrared digital thermometer sight handheld. Not a true scientific instrument but good enough to take some relative readings. After riding for about 1.5 hours, we parked and took measurements on both sides of the motorcycle, examining the temperature of the exposed plastic and the exposed frame in the area where the riders legs would be when riding. The highest readings were on the right side frame of the motorcycle near the intersection of the plastic and the frame. The readings on a recently ridden bike, parked with the engine off, ranged from 113 to 117 degrees. We had breakfast, giving the bike time to cool off, outside temperature became warmer, and after a 2 hour ride the temperature range taken in the same location on the motorcycle was 125 to 134 degrees. At this point ellen was complaining about the heat on her legs, which resulted in first degree burns. Today, i did some investigation on temperatures for various types of burns. Looking at the following website http://www.Nist.Gov/fire/fire_behavior.Cfm. This government organization website indicates this temperature can cause first and second degree burns. Therefore, the indicated temperature readings on the motorcycle is in a range to cause first to second degree burns. Assuming the measurements are accurate enough to indicate an issue, it appears your company has a significant health and safety issue with this model of motorcycle. The manufacture states getting burned is as designed

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.